Engine Overspeeds
Use this procedure in order to troubleshoot an engine overspeed or use this procedure if one of the following event codes is active. Refer to Troubleshooting, "Event Code List" for information about event codes and the default trip points for these codes. You must access the monitoring system on Caterpillar Electronic Technician (ET) in order to view the current trip points for these codes.
Show/hide table
Event Code | ||
---|---|---|
Code and Description | Conditions which Generate this Code | System Response |
E190(1) Engine Overspeed | The engine rpm has exceeded the trip point for engine overspeed for the delay time. | The code is logged.
The Electronic Control Module (ECM) will disable fuel injection for engine speeds that are above the trip point. |
- Intake air is combustible
- Sudden drop of load
Show/hide table
Troubleshooting Test Steps | Value | Results |
1. Proper Operation of the Turbocharger A. Check for proper operation of the turbocharger B. Check for any oil that may be leaking into the air inlet. |
Turbocharger |
Result: The turbocharger is not leaking oil into the inlet. Proceed to Test Step 2 The turbocharger is leaking oil into the inlet. Repair or replace the turbocharger. |
2. Intake Air is Combustible A. Check for combustible gases in the surrounding atmosphere. |
Intake air |
Result: There are no combustible gases in the surrounding atmosphere. Result: There are combustible gases in the surrounding atmosphere. Do not operate the engine in an environment with combustible gases. |
Caterpillar Information System:
3516B Engine Alternator - Remove and Install
C18 Generator set and C18 Marine Engines Engine Oil Pump - Remove
CX48-P2300 Petroleum Transmission Power Train Electronic Control System Electrical Connector - Inspect
C27 and C32 Engines for Caterpillar Built Machines Electronic Unit Injector Mechanism
C27 and C32 Engines for Caterpillar Built Machines Exhaust Gas Valve (NRS)
C280-16 Petroleum Engine Crankshaft Seals
2012/12/11 New Software is Used on C175-16 Generator Set Engines {1901, 1920}
2012/08/23 Kits Are Available for Repair of Exhaust Components on Certain 3516 Electric Power Engines with Center-Mounted Exhaust Systems {1052, 1053, 1059, 1061, 1071}
C32 Marine Engines Vibration Damper - Check
CX48-P2300 Petroleum Transmission Power Train Electronic Control System Determining Diagnostic Trouble Codes
CX48-P2300 Petroleum Transmission Power Train Electronic Control System Electronic Control Module (ECM) - Flash Program
C32 Marine Engines Engine Oil Pressure - Test
3516B Engine Electronic Control Module (Engine) - Remove and Install
C3.3B and C3.8 Engines for Caterpillar Built Machines Engine Monitoring System
C18 Marine Auxiliary and Marine Generator Set Engines Engine Top Speed Is Not Obtained
C280 Marine and Petroleum Engines Engine Cranks but Does Not Start
3516B Engine Fuel Transfer Pump - Disassemble
3516B Engine Fuel Transfer Pump - Assemble
2013/05/23 A New Gas Shutoff Valve (GSOV) Is Used for G3516B and G3520B Engines {1270, 5479}
784C and 785C Off-Highway Trucks Machine Systems Duo-Cone Seals - Install
G3600 Engines Water Pump
C27 and C32 Tier 4 Engines Exhaust Manifold
Software On Certain C9 Industrial Engines May Cause Engine Speed Instability or the Inability to Achieve Full Load{1000, 1920} Software On Certain C9 Industrial Engines May Cause Engine Speed Instability or the Inability to Achieve Full Load{1000, 1920}
C27 Generator Set Safety Messages