Engine Monitoring System
电子控制模块（ECM）为该发动机提供了一个综合、可编程的发动机监控系统。 ECM 监控指定的发动机操作参数，以检测可能会发生的异常情况。 如果特定发动机参数超过发动机监控系统所定义的可接受范围，则 ECM 将产生事件代码。 ECM 将会根据该情况的严重程度做出反应。 有关事件代码的信息，请参阅故障诊断与排除, "事件代码"。
以下行动可能由 ECM 触发。 这些行动取决于情况的严重程度。
- 点亮警告灯或警告报警
- 发动机减额
- 发动机停机
每个参数可能会具有以下三种响应。 有些响应对某些参数是无效的。 参考表 1。
Show/hide table
| 警告操作 | |||||
|---|---|---|---|---|---|
| 警告级别 | 警告指示 (1) | 操作员行动要求 | 可能出现的结果 (2) | ||
| 警报指示器闪亮 (3) | 行动灯闪烁 | 故障警报响起 | |||
| 1 | X | 无需立即行动。 系统需要即刻留意。 | 无害或损坏后果。 | ||
| 2 | X | X | 改变机器的操作方式或对系统进行保养。 | 损坏系统部件 | |
| 3 | X | X | X (4) | 立即对发动机进行安全停机。 | 操作员受伤或严重损坏部件。 |
Show/hide table
| (1) | 启用的警告指示用 "X" 符号表示。 |
| (2) | 如果操作员不采取行动，以下是可能出现的结果。 |
| (3) | 频率为 1/2 Hz。 |
| (4) | 脉动警报。 |
Caterpillar Information System:
3516B Engine Electronic Control Module (Engine) - Remove and Install
C18 Marine Auxiliary and Marine Generator Set Engines Engine Overspeeds
3516B Engine Alternator - Remove and Install
C18 Generator set and C18 Marine Engines Engine Oil Pump - Remove
CX48-P2300 Petroleum Transmission Power Train Electronic Control System Electrical Connector - Inspect
C27 and C32 Engines for Caterpillar Built Machines Electronic Unit Injector Mechanism
C27 and C32 Engines for Caterpillar Built Machines Exhaust Gas Valve (NRS)
C280-16 Petroleum Engine Crankshaft Seals
2012/12/11 New Software is Used on C175-16 Generator Set Engines {1901, 1920}
2012/08/23 Kits Are Available for Repair of Exhaust Components on Certain 3516 Electric Power Engines with Center-Mounted Exhaust Systems {1052, 1053, 1059, 1061, 1071}
C32 Marine Engines Vibration Damper - Check
CX48-P2300 Petroleum Transmission Power Train Electronic Control System Determining Diagnostic Trouble Codes
C18 Marine Auxiliary and Marine Generator Set Engines Engine Top Speed Is Not Obtained
C280 Marine and Petroleum Engines Engine Cranks but Does Not Start
3516B Engine Fuel Transfer Pump - Disassemble
3516B Engine Fuel Transfer Pump - Assemble
2013/05/23 A New Gas Shutoff Valve (GSOV) Is Used for G3516B and G3520B Engines {1270, 5479}
784C and 785C Off-Highway Trucks Machine Systems Duo-Cone Seals - Install
G3600 Engines Water Pump
C27 and C32 Tier 4 Engines Exhaust Manifold
Software On Certain C9 Industrial Engines May Cause Engine Speed Instability or the Inability to Achieve Full Load{1000, 1920} Software On Certain C9 Industrial Engines May Cause Engine Speed Instability or the Inability to Achieve Full Load{1000, 1920}
C27 Generator Set Safety Messages
C18 Generator set and C18 Marine Engines Engine Oil Pump - Install
3516B Engine Turbocharger - Remove