Electronic Control Module (Engine) - Remove and Install
- Turn the keyswitch to the OFF position.
Show/hide table
Illustration 1 g01213557 - Remove covers (2).
- Disconnect harness assemblies (3).
- Support ECM (4). Remove bolts (1) and disconnect ground strap assembly (5). Remove ECM (4).
Note: Rubber grommets behind ECM (4) are held in place by the mounting bolts. The grommets help to reduce vibration. The grommets may fall when the bolts and/or ECM (4) are removed.
Note: If the ECM is being replaced, download the personality module before you remove the ECM. Refer to Troubleshooting, "Replacing the ECM".
- Position ECM (4) and the grommets. Connect ground strap assembly (5) and install bolts (1).
Note: You should be able to move the ECM (4) after bolts (1) are installed.
- Connect harness assemblies (3).
- Install covers (2).
- Turn the keyswitch to the ON position.
Show/hide table
Illustration 2 | g01213557 |
Caterpillar Information System:
C18 Marine Auxiliary and Marine Generator Set Engines Engine Overspeeds
3516B Engine Alternator - Remove and Install
C18 Generator set and C18 Marine Engines Engine Oil Pump - Remove
CX48-P2300 Petroleum Transmission Power Train Electronic Control System Electrical Connector - Inspect
C27 and C32 Engines for Caterpillar Built Machines Electronic Unit Injector Mechanism
C27 and C32 Engines for Caterpillar Built Machines Exhaust Gas Valve (NRS)
C280-16 Petroleum Engine Crankshaft Seals
2012/12/11 New Software is Used on C175-16 Generator Set Engines {1901, 1920}
2012/08/23 Kits Are Available for Repair of Exhaust Components on Certain 3516 Electric Power Engines with Center-Mounted Exhaust Systems {1052, 1053, 1059, 1061, 1071}
C32 Marine Engines Vibration Damper - Check
CX48-P2300 Petroleum Transmission Power Train Electronic Control System Determining Diagnostic Trouble Codes
CX48-P2300 Petroleum Transmission Power Train Electronic Control System Electronic Control Module (ECM) - Flash Program
C3.3B and C3.8 Engines for Caterpillar Built Machines Engine Monitoring System
C18 Marine Auxiliary and Marine Generator Set Engines Engine Top Speed Is Not Obtained
C280 Marine and Petroleum Engines Engine Cranks but Does Not Start
3516B Engine Fuel Transfer Pump - Disassemble
3516B Engine Fuel Transfer Pump - Assemble
2013/05/23 A New Gas Shutoff Valve (GSOV) Is Used for G3516B and G3520B Engines {1270, 5479}
784C and 785C Off-Highway Trucks Machine Systems Duo-Cone Seals - Install
G3600 Engines Water Pump
C27 and C32 Tier 4 Engines Exhaust Manifold
Software On Certain C9 Industrial Engines May Cause Engine Speed Instability or the Inability to Achieve Full Load{1000, 1920} Software On Certain C9 Industrial Engines May Cause Engine Speed Instability or the Inability to Achieve Full Load{1000, 1920}
C27 Generator Set Safety Messages
C18 Generator set and C18 Marine Engines Engine Oil Pump - Install