Heat Exchanger - Remove and Install
- Refer to Operation and Maintenance Manual, "Coolant - Change" for the proper draining and filling procedures.
Show/hide table
Illustration 1 g03068539 - Disconnect hoses (4) and hose (1).
- Remove nuts (2) and bolts (5). Remove heat exchanger (3).
Show/hide table
Illustration 2 g03068541 - Remove bolts (7) and (8). Remove support (6).
- Install heat exchanger (3) in the reverse order of removal.
- Tighten bolts (7) to a torque of
115 ± 20 N·m (85 ± 15 lb ft) .
- Tighten bolts (7) to a torque of
Caterpillar Information System:
C3.3B and C3.8 Engines for Caterpillar Built Machines Data Link - Test
C18 Marine Engines Auxiliary Water Pump - Remove and Install - Fresh Water
C18 Marine Engines Auxiliary Water Pump - Remove and Install - Sea Water
C18 Marine Engines Water Temperature Regulator - Remove and Install - SCAC
C18 Marine Engines Water Temperature Regulator - Remove and Install - Jacket Water
C175-16 Engine Engine Air Cleaner Element (Single Element) - Inspect/Clean/Replace
C18 Marine Engines Water Pump - Remove and Install
C18 Marine Engines Marine Transmission Oil Cooler Core - Remove and Install
2012/06/06 A New Oil Fill Group Is Used on Certain C32 Petroleum Engines {1107}
C175-16 Engine Maintenance Recommendations
2012/06/15 Guidelines For Protecting Alternators Used on Certain Cat® Products {1405}
C18 Marine Engines Engine Oil Cooler - Remove and Install
C18 Marine Engines Heat Exchanger - Remove and Install - Sea Water
C18 Marine Engines Aftercooler - Remove and Install - Sea Air - Treated Water
3516C Generator Set Engines Fuel Injection Pump
3516C Generator Set Engines Turbocharger Oil Lines
3500 Generator Set Engines Air Inlet and Exhaust Lines
3500 Generator Set Engines Air Inlet and Exhaust Lines
3516C Generator Set Engines Turbocharger
3516C Generator Set Engines Turbocharger
C7.1 Industrial Engine Reference Information
3516C Generator Set Engines Air Lines
3516C Generator Set Engines Air Lines
3500 Marine Engines Air Shutoff