Crankshaft Rear Seal
Show/hide table
Required Tools | |||
Tool | Part Number | Part Description | Qty |
A | 1U-5593 | Drill Bit | 1 |
B | 1U-7600 | Slide Hammer Puller Gp | 1 |
Start By:
- Remove the flywheel.
- Use Tooling (A) to drill three evenly spaced holes in the crankshaft rear seal.
Show/hide table
Illustration 1 g01200319 - Use Tooling (B) in order to remove the outer half of rear crankshaft seal (1).
- Use Tooling (A) to drill three evenly spaced holes in the crankshaft rear seal.
Show/hide table
Illustration 2 g01200322 - Use Tooling (B) in order to remove the inner half of rear crankshaft seal (1).
Show/hide table
Required Tools | |||
Tool | Part Number | Part Description | Qty |
C | 250-4587 | Installer | 1 |
250-4586 | Locator | 1 | |
322-2078 | Bolt | 2 | |
9S-8858 | Nut | 1 |
- Use Tooling (C) to install crankshaft rear seal (1).
Note: Position the locator and install the bolts to hold in position. Install the seal over the locator and position the installer. Install the nut and turn until the nut stops. Inspect and remove tooling.
Show/hide table
Illustration 3 | g01200381 |
End By:
- Install the flywheel.
Caterpillar Information System:
C175-16 Marine Engine Gear Group (Rear)
C175-16 Marine Engine Aftercooler
C175-16 Marine Engine Auxiliary Water Pump
C175-16 Marine Engines On-Board Replacement Parts
C175-16 Marine Engine Water Pump
2012/02/08 Turbocharger on Certain C6.6 Engines {1052, 1053, 1348}
C3.4B Engines for Caterpillar Built Machines Diesel Particulate Filter - Clean
C175-16 Marine Engine Engine Oil Pump
C175-16 Marine Engine Engine Oil Cooler
Measuring Wear on Bucket Base Edges (Determining Useful Life) {6101} Measuring Wear on Bucket Base Edges (Determining Useful Life) {6101}
C175-16 Marine Engines Fuel System Secondary Filter - Replace
C175-16 Marine Engine Inlet and Exhaust Valve Seals
C175-16 Marine Engine Front Drive Housing
C175-16 Marine Engine Crankshaft Front Seal
C175-16 Marine Engine Idler Gears (Front)
3516C Industrial Engine Model View Illustrations
1U-8846 Gasket Sealant Has Been Removed From 3N-5904 Gear Seal Kit {1000, 7000} 1U-8846 Gasket Sealant Has Been Removed From 3N-5904 Gear Seal Kit {1000, 7000}
C175-16 Marine Engine Crankcase Breather
C175-16 Marine Engine Rocker Shaft and Push Rods
C175-16 Marine Engine Rocker Shaft
C175-16 Marine Engine Cylinder Head
C175-16 Marine Engines Zinc Rods - Inspect/Replace
C175-16 Marine Engine Valve Lifter
2012/02/07 New Improved Hybrid Fuel lines Are Now Used on Certain C11 and C13 Industrial Engines {1274}