Crankshaft Front Seal
Show/hide table
Required Tools | |||
Tool | Part Number | Part Description | Qty |
A | 1U-5593 | Drill Bit | 1 |
B | 1U-7600 | Slide Hammer Puller Gp | 1 |
Start By:
- Remove the vibration damper. Refer to Disassembly and Assembly, "Vibration Damper - Remove and Install ".
- Use Tooling (A) to drill three evenly spaced holes in the crankshaft front seal.
Show/hide table
Illustration 1 g01208062 - Use Tooling (B) in order to remove the outer half of crankshaft front seal (1).
- Use Tooling (A) to drill three evenly spaced holes in the crankshaft front seal.
Show/hide table
Illustration 2 g01208063 - Use Tooling (B) in order to remove the inner half of crankshaft front seal (1).
Show/hide table
Required Tools | |||
Tool | Part Number | Part Description | Qty |
C | 250-4587 | Installer | 1 |
250-4586 | Locator | 1 | |
322-2078 | Bolt | 2 | |
9S-8858 | Nut | 1 |
- Use Tooling (C) to install crankshaft front seal (1).
Note: Position the locator and install the bolts to hold in position. Install the seal over the locator and position installer. Install nut and turn until the nut stops. Inspect and remove tooling.
Show/hide table
Illustration 3 | g01208138 |
End By:
- Install the vibration damper.
Caterpillar Information System:
C175-16 Marine Engine Front Drive Housing
C175-16 Marine Engine Crankshaft Rear Seal
C175-16 Marine Engine Gear Group (Rear)
C175-16 Marine Engine Aftercooler
C175-16 Marine Engine Auxiliary Water Pump
C175-16 Marine Engines On-Board Replacement Parts
C175-16 Marine Engine Water Pump
2012/02/08 Turbocharger on Certain C6.6 Engines {1052, 1053, 1348}
C3.4B Engines for Caterpillar Built Machines Diesel Particulate Filter - Clean
C175-16 Marine Engine Engine Oil Pump
C175-16 Marine Engine Engine Oil Cooler
Measuring Wear on Bucket Base Edges (Determining Useful Life) {6101} Measuring Wear on Bucket Base Edges (Determining Useful Life) {6101}
C175-16 Marine Engine Idler Gears (Front)
3516C Industrial Engine Model View Illustrations
1U-8846 Gasket Sealant Has Been Removed From 3N-5904 Gear Seal Kit {1000, 7000} 1U-8846 Gasket Sealant Has Been Removed From 3N-5904 Gear Seal Kit {1000, 7000}
C175-16 Marine Engine Crankcase Breather
C175-16 Marine Engine Rocker Shaft and Push Rods
C175-16 Marine Engine Rocker Shaft
C175-16 Marine Engine Cylinder Head
C175-16 Marine Engines Zinc Rods - Inspect/Replace
C175-16 Marine Engine Valve Lifter
2012/02/07 New Improved Hybrid Fuel lines Are Now Used on Certain C11 and C13 Industrial Engines {1274}
2012/02/27 An Alternate Repair Option Is Used for the Cat 270 Air Compressor {1803}
2015/08/07 Tab Must Be Removed on Certain Turbochargers That Are Equipped on Certain C7 and C9 On-Highway Truck Engines {1052, 1053}