Rocker Shaft and Push Rods
Start By:
- Remove the valve cover. Refer to Disassembly and Assembly, "Valve Cover - Remove and Install".
- Remove bolts (1). Remove rocker shaft assembly (2).
Show/hide table
Illustration 2 g02091240 - Remove pushrods (3). Remove bridges (4).
Show/hide table
Illustration 1 | g02091239 |
- Install bridges (4) on the cylinder head. Position the round pocket toward the outside of the engine. Lubricate pushrods (3) with clean engine oil. Install pushrods (3). Seat pushrods (3) in the lifter cups.
Note: Ensure that the pushrods are seated in the bores. Use a flashlight in order to ensure that the pushrods are in the lifter cups.
Show/hide tableIllustration 5 g02091239 - Position rocker shaft assembly (2) in the dowel holes. Install bolts (1). Tighten bolts (1) to a torque of
200 ± 30 N·m (147 ± 22 lb ft) . - Adjust the valve lash. Refer to Testing and Adjusting, "Engine Valve Lash - Inspect/Adjust".
- Lubricate bridges (4) and the pockets with clean engine oil.
Show/hide table
Illustration 3 | g02091240 |
Show/hide table
Illustration 4 | g01949432 |
End By:
- Install the valve cover. Refer to Disassembly and Assembly, "Valve Cover - Remove and Install".
Caterpillar Information System:
C175-16 Marine Engine Crankcase Breather
1U-8846 Gasket Sealant Has Been Removed From 3N-5904 Gear Seal Kit {1000, 7000} 1U-8846 Gasket Sealant Has Been Removed From 3N-5904 Gear Seal Kit {1000, 7000}
3516C Industrial Engine Model View Illustrations
C175-16 Marine Engine Idler Gears (Front)
C175-16 Marine Engine Crankshaft Front Seal
C175-16 Marine Engine Front Drive Housing
C175-16 Marine Engine Crankshaft Rear Seal
C175-16 Marine Engine Gear Group (Rear)
C175-16 Marine Engine Aftercooler
C175-16 Marine Engine Auxiliary Water Pump
C175-16 Marine Engines On-Board Replacement Parts
C175-16 Marine Engine Water Pump
C175-16 Marine Engine Rocker Shaft
C175-16 Marine Engine Cylinder Head
C175-16 Marine Engines Zinc Rods - Inspect/Replace
C175-16 Marine Engine Valve Lifter
2012/02/07 New Improved Hybrid Fuel lines Are Now Used on Certain C11 and C13 Industrial Engines {1274}
2012/02/27 An Alternate Repair Option Is Used for the Cat 270 Air Compressor {1803}
2015/08/07 Tab Must Be Removed on Certain Turbochargers That Are Equipped on Certain C7 and C9 On-Highway Truck Engines {1052, 1053}
C175-16 Marine Engine Camshaft
C175-16 Marine Engine Camshaft Bearings
C175-16 Marine Engine Piston Cooling Jets
3500B High Displacement Locomotive Engines Connecting Rod
3500C Marine Engines Product Lifting