Electronic Control Module - Remove and Install
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Disconnect the negative battery terminal at the battery.
Show/hide table
Illustration 1 g02476756 - Disconnect harness assembly (1).
- Remove bolts (3) and plate assembly (2).
Show/hide table
Illustration 2 g02476773 - Loosen allen head screws (7). Disconnect harness assembly (6) and harness assembly (8) from electronic control module (10).
- Disconnect connector (9) and remove harness assembly (6) and harness assembly (8) from bracket assembly (11).
- Remove bolts (5), ground strap (4), the isolation mounts, the spacers, and electronic control module (10).
- If necessary, remove bracket assembly (11).
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- If necessary, install bracket assembly (11).
- Position the isolation mounts, the spacers, and electronic control module (10) on the support assemblies. Install ground strap (4) and bolts (5).
- Position harness assembly (8) and harness assembly (6) in bracket assembly (11) and connect connector (9). Tighten connector (9) to a torque of
45 ± 5 N·m (33 ± 4 lb ft) . - Connect harness assembly (8) and harness assembly (6) to electronic control module (10). Tighten allen head screws (7) to a torque of
6 ± 1 N·m (53 ± 9 lb in) .Show/hide tableIllustration 4 g02476756 - Install plate assembly (2) and bolts (3).
- Connect harness assembly (1).
- Connect the negative battery terminal at the battery.
Show/hide table
Illustration 3 | g02476773 |
Caterpillar Information System:
G3500J Engines Refill Capacities
3116 and 3126 Marine Engines Coolant - Change
C4.4 Industrial Engine Exhaust Elbow - Remove and Install - Top Mounted and Side Mounted Turbocharger Exhaust Elbow
C27 Generator Set Hoses and Clamps - Inspect/Replace
C3.4B Industrial Engine Monitoring System - Table for the Indicator lamps
C27 Generator Set Generator Operation
UPSB505 Uninterruptible Power Supply UPS Characteristics
G3304B and G3306B Engines Configuration Parameters
C15 and C18 Petroleum Generator Sets Configuration Parameters
G3304B and G3306B Engines Sensors and Electrical Components
UPSB505 Uninterruptible Power Supply Mimic Panel Indicator
UPSB505 Uninterruptible Power Supply Life Cycle Monitoring
C3.4B Industrial Engine Sensors and Electrical Components - Aftertreatment
XQ60 Rental Generator Set Sensors and Electrical Components
C15 and C18 Petroleum Generator Sets Refill Capacities
G3516 Petroleum Engine Control Panel - Inspect/Test
G3304B and G3306B Engines Before Starting Engine
G3304B and G3306B Engines Starting with Jump Start Cables
C15 Petroleum Engines Electrical Power Supply - Test
G3304B and G3306B Engines Engine Performance - Test
C15 Petroleum Engines Air Shutoff - Remove and Install
G3500 Engines Coolant Level - Check
G3500 Engines Coolant (DEAC) - Change
300.9D and 300.9D VPS Mini Hydraulic Excavator Engine Valve Lash - Check/Adjust