Coolant Level - Check
Show/hide table
Show/hide table
注意 |
---|
冷却液溢流罐(如有配备)加注过满,会造成冷却系统的损坏。 如果冷却系统有溢流罐,保持冷却液液位低于溢流罐的一半位置,以免损坏冷却系统。 |
Show/hide table
图 1 | g00760290 |
额定工况运行时目测表上冷却液的正常液位 |
观察目测表(如有配备)上的冷却液液位。 当发动机在正常工作温度下运行时,液位应处于目测表的上半部。 如果冷却液液位过低,添加正确的冷却剂混合液。
注: 为确保使用正确的冷却液混合液,请参阅本操作和保养手册, "油液建议"标题和本操作和保养手册, "加注容量"标题。
- 停止发动机。 让发动机冷却。
- 慢慢拆下冷却系统加注口盖,以释放掉压力。 将正确的冷却剂混合液注入冷却液加注管。
Show/hide table
图 2 g00103639 加注口盖垫片 - 清洗冷却系统加注口盖。 检查冷却系统加注口盖密封垫的状况。 如果冷却系统加注口盖密封垫损坏,请用新件更换旧的冷却系统加注口盖。 安装冷却系统加注口盖。
- 起动发动机。 检查冷却系统有无泄漏。
Caterpillar Information System:
C15 Petroleum Engines Air Shutoff - Remove and Install
G3304B and G3306B Engines Engine Performance - Test
C15 Petroleum Engines Electrical Power Supply - Test
G3304B and G3306B Engines Starting with Jump Start Cables
G3304B and G3306B Engines Before Starting Engine
G3516 Petroleum Engine Control Panel - Inspect/Test
C15 and C18 Petroleum Generator Sets Refill Capacities
XQ60 Rental Generator Set Sensors and Electrical Components
C3.4B Industrial Engine Sensors and Electrical Components - Aftertreatment
C15 Petroleum Engines Electronic Control Module - Remove and Install
G3500J Engines Refill Capacities
3116 and 3126 Marine Engines Coolant - Change
G3500 Engines Coolant (DEAC) - Change
300.9D and 300.9D VPS Mini Hydraulic Excavator Engine Valve Lash - Check/Adjust
C4.4 Industrial Engine Turbocharger - Install - Top Mounted Turbocharger
C4.4 Industrial Engine Turbocharger - Remove - Top Mounted Turbocharger
C4.4 Industrial Engine Turbocharger - Remove - Side Mounted Turbochargers
C4.4 Industrial Engine Turbocharger - Install - Side Mounted Turbochargers
2011/04/04 An Updated Procedure for Manual Engine Shutdown in the Engine Operation and Maintenance Manual (OMM) Is Available {1000}
C15 and C18 Petroleum Generator Sets Control Panel - Inspect/Test
C15 and C18 Petroleum Generator Sets Coolant (DEAC) - Change
C15 and C18 Petroleum Generator Sets Coolant Level - Check
G3304B and G3306B Engines Control Panel - Inspect/Test
G3406 Engine Battery - Replace