Aftercooler Core - Remove and Install
Start By:
- Remove the ladder.
- Remove bolts (1). Use two people in order to remove grill (2) and grill (3). The weight of each grill (2) and grill (3) is approximately
32 kg (70 lb) .Show/hide tableIllustration 2 g02025894 - Disconnect harness assemblies (4) and remove the connecting hardware.
Show/hide table
Illustration 3 g02025886 - Attach a suitable lifting device onto handrail (5) and cover (6). The weight of handrail (5) and cover (6) is approximately
111 kg (245 lb) . Remove bolts (7). Remove bolts (8). Remove handrail (5) and cover (6).Show/hide tableIllustration 4 g02025899 - Remove bolts (9).
Show/hide table
Illustration 5 g02025840 - Remove bracket assembly (10). Disconnect tube (11).
Show/hide table
Illustration 6 g02025842 - Disconnect tube (12).
Show/hide table
Illustration 7 g02025846 - Attach a suitable lifting device onto aftercooler core (13). The weight of aftercooler core (13) is approximately
104 kg (230 lb) . - Remove bolts (14). Remove bracket assembly (15). Remove aftercooler core (13).
Show/hide table
Illustration 1 | g02025483 |
- Install aftercooler core (13) in the reverse order of removal.
Caterpillar Information System:
G3304B and G3306B Engines Fuel Actuator - Test
12M Motor Grader Fire Extinguisher Location
G3304B and G3306B Engines Oxygen Sensor
3508C, 3512C and 3516C Locomotive Engines Water Lines
3508C, 3512C and 3516C Locomotive Engines Water Lines
349F and 352F Excavators Circuit Breakers - Reset
349F and 352F Excavators Hydraulic System Oil Filter (Return) - Replace
C13, C15, and C18 Tier 4 Interim Engines Aftertreatment Identification Module - Test
349F and 352F Excavators Travel Alarm - Test - If Equipped
3508, 3512 and 3516 Generator Set Engines Flywheel Housing - Remove and Install
2010/01/08 A New Oil Pan Gasket Is Used for Certain C18 Marine Engines, and Available for Certain 3406E and C15 and C18 Marine Engines {1302, 7555}
793F Off-Highway Truck Engine Supplement Hood - Remove and Install
2009/12/10 Enhanced Performance for the Regeneration System on C13 and C15 Engines {1901, 1920}
349F and 352F Excavators ARD Spark Plug - Clean
G3304B and G3306B Engines Starting - Test
3508, 3512 and 3516 Generator Set Engines Valve Cover - Remove and Install
3508, 3512 and 3516 Generator Set Engines Rocker Shaft and Push Rods - Remove and Install
C9.3 Engines for Caterpillar Built Machines Cylinder Is Noisy
C15 Engine Stopping the Engine
G3304B and G3306B Engines Aftercooler - Test - If Equipped
Guideline for Roller and Idler Component Reuse {4159, 4180} Guideline for Roller and Idler Component Reuse {4159, 4180}
G3304B and G3306B Engines Cooling System - Check
793F Off-Highway Truck Engine Supplement Air Cleaner - Remove and Install
C32 Marine Engine Oil Cooler Core - Check/Clean/Test - Engines Which Are Rated "E"