Piston Motor (Hydraulic Fan)
Show/hide table
图 1 | g03388299 |
Show/hide table
240-7790 活塞马达总成 的技术规格     | |||
项目     | 数量     | 零件     | 技术规格说明     |
1     | 8     | 9T-4467 螺栓     | 拧紧至扭矩为 350 ± 15 N·m (258 ± 11 lb ft)。     |
2     | 1     | 257-2168 驱动轴     | 轴的旋转是双向的。 每圈排量 355 cc (22 cu. in.)。     |
3     | 2     | 135-8853 螺塞     | 拧紧扭矩至 30 N·m (266 lb in)。     |
Show/hide table
图 2 | g03388298 |
Show/hide table
项目     | 数量     | 零件     | 技术规格说明     |
4     | 14     | 101-2465 螺栓     | 拧紧至扭矩为 37 N·m (27 lb ft)。     |
5     | 根据需要,使用以下垫片以便获得 0.25 至 0.35 mm (0.010 至 0.014 in) 的尺寸 (B) 。     |
||
1 | 191-0666 隔套套件     | 套件包括 16 个不同厚度的隔套,从 1.70 到 3.00 mm (0.067 到 0.118 in)。     |
|
6     | 1     | 191-0654 螺钉     | 拧紧扭矩至 8 N·m (71 lb in)。     |
7     | 1     | 191-0653 弹簧     | 自由长度为 93.6 mm (3.69 in)。     |
8     | 根据需要,使用以下垫片以便获得 148.00 ± 0.05 mm (5.827 ± 0.002 in) (A) 的尺寸 ( A) :     |
||
1 | 257-2173 垫片套件     | 套件包括 7 个不同厚度的隔套,从 7.40 到 8.40 mm (0.291到 0.331 in)。     |
|
9     | 1     | 257-2156 弹簧     | 自由长度为 24.0 mm (0.94 in)。     |
Caterpillar Information System:
CB-214E, CB-224E and CB-225E Paving Compactors System Pressure Release
Replacement Procedure for the Service Meter{7478} Replacement Procedure for the Service Meter{7478}
C175-16 and C175-20 Generator Set Engines System Overview
345D MHPU and 349D MHPU Mobile Hydraulic Power Units Machine System Boom Cylinder Lines
345D, 349D and 349D2 Excavator Machine System Specifications Pilot Lines - Pump and Motor
3500 Petroleum Engines and Petroleum Generator Sets Configuration Parameters
3524B and C175 Engines for Off-Highway Truck/Tractors Fuel Injector
C13 On-highway Engine Turbocharger
345D, 349D and 349D2 Excavator Machine System Specifications Pilot Lines - Control Valve
2008/03/17 A New Drain Line for the Turbocharger is Now Used {1052, 1307}
3512C Engine Maintenance Recommendations
Proper Assembly Sequences for Installing Air Inlet Heater Relay (12VDC Relay: 175-2301 Magnetic Switch, 24VDC Relay: 148-0757 Magnetic Switch){1090, 1408} Proper Assembly Sequences for Installing Air Inlet Heater Relay (12VDC Relay: 175-2301 Magnetic Switch, 24VDC Relay: 148-0757 Magnetic Switch){1090, 1408}
345D, 349D and 349D2 Excavator Machine System Specifications Pilot Valve - Boom Down Relief
Software Configuration Guide {3168, 4800, 4808, 7600, 7610, 7620} Software Configuration Guide {3168, 4800, 4808, 7600, 7610, 7620}
Bench Test Procedure For A CX28 On-Highway Transmission {3030, 3073} Bench Test Procedure For A CX28 On-Highway Transmission {3030, 3073}
G3520C and G3520E Generator Set Engines Camshaft - Remove
G3520C and G3520E Generator Set Engines Camshaft - Install
303.5E2 CR, 304E2 CR, 305E2 CR and 305.5E2 CR Mini Hydraulic Excavators Machine Systems Swing Drive
2008/03/17 A New Starter Solenoid is Now Available {1467}
C175-16 and C175-20 Generator Set Engines Starting - Test
C175-16 and C175-20 Generator Set Engines Sensor Signal (Analog, Active) - Test
349F and 352F Excavators Machine System Specifications Swing Cushion Valve with Fine Swing Solenoid Valve
C32 Marine Engine Configuration Parameters
C32 Marine Engine Diagnostic Flash Code Retrieval