Boom Cylinder Lines
Show/hide table
图 1 | g01486356 |
顶视图 |
(1) 将 5H-2471 粘接剂 涂抹在 2 个护罩的表面上。
(2) 软管组件的扭矩 ... 160 ± 16 N·m (118 ± 12 lb ft)
Show/hide table
图 2 | g01486373 |
右视图 |
注: 组装前,在压力传感器 (3) 外螺纹的外径上涂抹一薄层清洁的液压油。
(3) 压力传感器的扭矩 ... 100 ± 10 N·m (74 ± 7 lb ft)
(4) 放油螺钉的扭矩 ... 12.7 ± 2.0 N·m (112.4 ± 17.7 lb in)
Caterpillar Information System:
345D, 349D and 349D2 Excavator Machine System Specifications Pilot Lines - Pump and Motor
3500 Petroleum Engines and Petroleum Generator Sets Configuration Parameters
3524B and C175 Engines for Off-Highway Truck/Tractors Fuel Injector
C13 On-highway Engine Turbocharger
345D, 349D and 349D2 Excavator Machine System Specifications Pilot Lines - Control Valve
2008/03/17 A New Drain Line for the Turbocharger is Now Used {1052, 1307}
3512C Engine Maintenance Recommendations
Proper Assembly Sequences for Installing Air Inlet Heater Relay (12VDC Relay: 175-2301 Magnetic Switch, 24VDC Relay: 148-0757 Magnetic Switch){1090, 1408} Proper Assembly Sequences for Installing Air Inlet Heater Relay (12VDC Relay: 175-2301 Magnetic Switch, 24VDC Relay: 148-0757 Magnetic Switch){1090, 1408}
Parts to Replace in the Event of Hydraulic Lock or Piston to Valve Contact{1000, 1102, 1216, 1225, 1250, 1290} Parts to Replace in the Event of Hydraulic Lock or Piston to Valve Contact{1000, 1102, 1216, 1225, 1250, 1290}
345D, 349D and 349D2 Excavator Machine System Specifications Pilot Lines - Control Valve
Some 3500 Cylinder Packs May Have Incorrect Pistons{1225} Some 3500 Cylinder Packs May Have Incorrect Pistons{1225}
Procedure to Install a Service Kit for the Unloader for the Air Compressor{1803} Procedure to Install a Service Kit for the Unloader for the Air Compressor{1803}
C175-16 and C175-20 Generator Set Engines System Overview
Replacement Procedure for the Service Meter{7478} Replacement Procedure for the Service Meter{7478}
CB-214E, CB-224E and CB-225E Paving Compactors System Pressure Release
793F and 793F XQ Off-Highway Truck Hydraulic Fan and Steering System Piston Motor (Hydraulic Fan)
345D, 349D and 349D2 Excavator Machine System Specifications Pilot Valve - Boom Down Relief
Software Configuration Guide {3168, 4800, 4808, 7600, 7610, 7620} Software Configuration Guide {3168, 4800, 4808, 7600, 7610, 7620}
Bench Test Procedure For A CX28 On-Highway Transmission {3030, 3073} Bench Test Procedure For A CX28 On-Highway Transmission {3030, 3073}
G3520C and G3520E Generator Set Engines Camshaft - Remove
G3520C and G3520E Generator Set Engines Camshaft - Install
303.5E2 CR, 304E2 CR, 305E2 CR and 305.5E2 CR Mini Hydraulic Excavators Machine Systems Swing Drive
2008/03/17 A New Starter Solenoid is Now Available {1467}
C175-16 and C175-20 Generator Set Engines Starting - Test