2014/10/20 Caterpillar


An Improved Single Tilt Brace Is Now Used On Certain D9R and D9T Track-Type Tractors {6050, 6061}

Usage:

D9T REX
Track-Type Tractor:
D9R (S/N: WDM1-UP)
D9T (S/N: TWG1-UP; RJS1-UP; REX1-UP)
Service Magazine, SEPD1872, 20 October 2014, "An Improved Single Tilt Brace Is Now Used On Certain D9R and D9T Track-Type Tractors". Disregard this article. See the replacement article that follows.

Description of Change: An improved 6I-8087 Brace (Single Tilt) is now used on certain D9R and D9T Track-Type Tractors. This brace has two improvements that will eliminate cracking on both ends.

The new brace has a reduced weld gap and an increased weld size between the side plates and the rod eye casting. The reduced weld gap will eliminate cracking at this location. See the Illustrations below.

The new brace also has a modified top plate to reduce stress and an increased cross sectional area near the bolt holes to increase service life.

Adaptable To: This improvement is effective with the following machines:

  • D9R (S/N: WDM4299-UP)

  • D9T (S/N: REX375-UP; RJS78005-UP; TWG647-UP)

This improvement is adaptable to the following machines:

  • D9R (S/N: WDM1-4298)

  • D9T (S/N: REX1-374; RJS1-78004; TWG1-646)




Illustration 1g03737950



Illustration 2g03738002

Old design




Illustration 3g03738013

New design

Caterpillar Information System:

335F CR Excavator C7.1 Engine Supplement Flexible Exhaust Pipe - Remove and Install
C27 and C32 Engines for Caterpillar Built Machines Coolant Flow - Test
C27 and C32 Engines for Caterpillar Built Machines Aftertreatment Identification Module - Test
335F CR Excavator C7.1 Engine Supplement Soot Sensor - Remove and Install
Fuel Lines Rework on Certain D11T Tier 2 Track-Type Tractors{1274} Fuel Lines Rework on Certain D11T Tier 2 Track-Type Tractors{1274}
D7E Track-Type Tractor Engine Supplement Hood - Remove and Install
D7E Track-Type Tractor Engine Supplement Pump Drive - Remove and Install
335F CR Excavator C7.1 Engine Supplement Engine Oil Cooler - Remove and Install
335F CR Excavator C7.1 Engine Supplement Fuel Cooler - Remove and Install
980L Medium Wheel Loader Power Train, Steering, Braking, Hydraulic, and Machine Systems Steering Pump
D6K2 and D6K Track-Type Tractor Systems Crossover Relief Valve (Winch) - Test and Adjust
C280 Marine Engines NOx Conversion Is Low
335F CR Excavator C7.1 Engine Supplement Hood - Remove and Install - Engine
2015/03/12 An Improved Window Guide and Rail Are Now Being Used on Certain Wheel Loaders {7310}
2015/01/27 New Engine Software Is Used For Certain D11 Track-Type Tractors {1920, 7620}
A New Autolube Pump and Internal Circuit Board Are Now Available for Certain Wheel Loaders and Articulated Trucks {1408, 7516, 7540, 7610, 7620} A New Autolube Pump and Internal Circuit Board Are Now Available for Certain Wheel Loaders and Articulated Trucks {1408, 7516, 7540, 7610, 7620}
D3K2, D4K2 and D5K2 Track-Type Tractor Systems Electronic Control (Power Train System)
D7E Track-Type Tractor Engine Supplement Access Doors/Covers - Remove and Install
335F CR Excavator C7.1 Engine Supplement Hood - Remove and Install - Clean Emissions Module
335F CR Excavator C7.1 Engine Supplement Clean Emissions Module - Remove and Install
926M, 930M and 938M Wheel Loaders Machine Systems Window Wiper and Wiper Motor (Front) - Remove and Install
D7E Track-Type Tractor Engine Supplement Turbocharger - Remove and Install
926M, 930M and 938M Wheel Loaders Machine Systems Window Wiper and Wiper Motor (Rear) - Remove and Install
930K Wheel Loader Machine Systems Refrigerant Accumulator - Remove and Install
Back to top
The names Caterpillar, John Deere, JD, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
CH-Part.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only.