Camshaft Bearings - Remove
Show/hide table
Required Tools | |||
---|---|---|---|
Tool | Part Number | Part Description | Qty |
A | 8S-2241 | Camshaft Bearing Tool Group | 1 |
B | 9U-7222 | Camshaft Bearing Pilot | 1 |
8M-8778 | Taperlock Stud 1/2 - 13 by 1 9/16 inch |
1 | |
C | 9U-7210 | Puller Plate | 1 |
Start By:
- Remove the camshaft. Refer to Disassembly and Assembly, "Camshaft - Remove".
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Remove the No. 7 camshaft bearing (rear). Work from the rear of the engine to the front of the engine.
- Install the small end of Tooling (B) in camshaft bearing (1).
- Position Tooling (C) over Tooling (A). Install Tooling (A) through the cylinder head on Tooling (B).
Note: Tooling (C) is installed on the outside of the cylinder head. Tooling (C) is required in order to remove all the camshaft bearings from the cylinder head.
- Use Tooling (A) to remove camshaft bearing (1) from the cylinder head.
- Remove Tooling (B) from Tooling (A) and remove the camshaft bearing.
Show/hide table
Illustration 1 | g01159745 |
Caterpillar Information System:
C175 Generator Set Engines Crankshaft Front Seal - Install
324D, 325D, 326D and 329D Excavators and 329D MHPU Mobile Hydraulic Power Unit Machine Systems Seat Support - Remove and Install
324D, 325D, 326D and 329D Excavators and 329D MHPU Mobile Hydraulic Power Unit Machine Systems Seat Suspension - Remove and Install
2005/10/03 Caterpillar Warranty Claims on Cylinder Head Valves {1105}
C175 Generator Set Engines Crankshaft Front Seal - Remove
2005/10/01 Caterpillar Warranty Claims on Cylinder Head Valves {1105}
TH48-E80 Petroleum Transmission Power Train Electronic Control System Speed Sensor (Transmission Output) - Replace
C175 Generator Set Engines Exhaust Elbow - Remove and Install
C32 Petroleum Engines Inlet Air Temperature Sensor - Remove and Install
C32 Petroleum Engines Turbocharger Outlet Pressure Sensor - Remove and Install
320E and 323E Excavators Machine System Specifications Solenoid Valve (Quick Coupler)
C1.5 and C2.2 Generator Set Engines Engine Enclosure Group - Remove and Install
C32 Petroleum Engines Camshaft Bearings - Install
C32 Petroleum Engines Camshaft - Install
3500 Engines Fuel Transfer Pump
C27 and C32 Generator Set Engines Electronic Control Module - Remove and Install
C6.6 Engines for Caterpillar Built Machines Charging System - Test
C6.6 Engines for Caterpillar Built Machines Alternator - Test
C32 Petroleum Engines Alternator - Remove and Install
3612 and 3616 Engines Fuel Pressure Control Valve - Remove
C175 Generator Set Engines Front Drive Housing - Remove and Install
C15 On-Highway Engine Fuel Transfer Pump
345C Excavator and 345C MHPU Mobile Hydraulic Power Unit Machine Systems Counterweight - Remove and Install
3612 and 3616 Engines Fuel Pressure Control Valve - Install