Fuel Temperature Sensor - Remove and Install
Show/hide table
| NOTICE |
|---|
|
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting, and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids. Refer to Special Publication, NENG2500, "Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Cat products. Dispose of all fluids according to local regulations and mandates. |
Show/hide table
| NOTICE |
|---|
|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Turn the fuel supply valve to the OFF position.
- Disconnect harness assembly (1).
- Remove fuel temperature sensor (2) from the fuel filter base.
- Remove the O-ring seal from fuel temperature sensor (2).
Show/hide table
| |
| Illustration 1 | g01207904 |
Show/hide table
| NOTICE |
|---|
|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Install a new O-ring seal on fuel temperature sensor (2).
- Install fuel temperature sensor (2) and tighten to a torque of
20 ± 5 N·m (15 ± 4 lb ft) . - Connect harness assembly (1).
- Turn the fuel supply valve to the ON position.
Show/hide table
|
| |
| Illustration 2 | g01207904 |
Caterpillar Information System:
3408E and 3412E Engines for Caterpillar Built Machines Cylinder Liner
324D, 325D, 326D and 329D Excavators and 329D MHPU Mobile Hydraulic Power Unit Machine Systems Window Wiper Motor - Remove and Install - Lower
345C Excavator and 345C MHPU Mobile Hydraulic Power Unit Machine Systems Final Drive - Disassemble
C32 Petroleum Engines Fuel Pressure Sensor - Remove and Install
3500 and 3500B High Displacement Engines for Caterpillar Built Machines Auxiliary Water Pump - Assemble
C32 Petroleum Engines Engine Oil Pressure Sensor - Remove and Install
C32 Petroleum Engines Coolant Temperature Sensor - Remove and Install
345C MHPU Mobile Hydraulic Power Unit Machine Systems Seat - Remove and Install
C32 Petroleum Engines Crankshaft Position Sensor - Remove and Install
345C MHPU Mobile Hydraulic Power Unit Machine Systems Pilot Valve (Travel) - Install
3512C Engine for 785D Off-Highway Truck/Tractors Engine Design
3512C and 3516C Marine Engines Engine Design
324D, 325D, 326D and 329D Excavators and 329D MHPU Mobile Hydraulic Power Unit Machine Systems Actuator Motor (Air Distributor) - Remove and Install
345C MHPU Mobile Hydraulic Power Unit Machine Systems Fuel Tank - Remove
345C MHPU Mobile Hydraulic Power Unit Machine Systems Fuel Tank - Install
2005/10/03 Starting the Engine with Jumper Cables on Machines with an Electric Starter {1000, 7000}
2005/10/03 Caterpillar Warranty Claims on Cylinder Head Valves {1105}
C1.5 and C2.2 Generator Set Engines Engine Enclosure Group - Remove and Install
320E and 323E Excavators Machine System Specifications Solenoid Valve (Quick Coupler)
C32 Petroleum Engines Turbocharger Outlet Pressure Sensor - Remove and Install
C32 Petroleum Engines Inlet Air Temperature Sensor - Remove and Install
C175 Generator Set Engines Exhaust Elbow - Remove and Install
TH48-E80 Petroleum Transmission Power Train Electronic Control System Speed Sensor (Transmission Output) - Replace
2005/10/01 Caterpillar Warranty Claims on Cylinder Head Valves {1105}