Engine Oil Pressure Sensor - Remove and Install
Show/hide table
| NOTICE |
|---|
|
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting, and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids. Refer to Special Publication, NENG2500, "Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Cat products. Dispose of all fluids according to local regulations and mandates. |
Show/hide table
| NOTICE |
|---|
|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Disconnect harness assembly (2).
- Remove engine oil pressure sensor (1) from the adapter on the cylinder block.
- Remove the O-ring seal from engine oil pressure sensor (1).
Show/hide table
| |
| Illustration 1 | g01207731 |
Show/hide table
| NOTICE |
|---|
|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Install a new O-ring seal on engine oil pressure sensor (1).
- Install engine oil pressure sensor (1) and tighten to a torque of
10 ± 2 N·m (89 ± 18 lb in) . - Connect harness assembly (2).
Show/hide table
|
| |
| Illustration 2 | g01207731 |
Caterpillar Information System:
C32 Petroleum Engines Coolant Temperature Sensor - Remove and Install
345C MHPU Mobile Hydraulic Power Unit Machine Systems Seat - Remove and Install
C32 Petroleum Engines Crankshaft Position Sensor - Remove and Install
345C MHPU Mobile Hydraulic Power Unit Machine Systems Pilot Valve (Travel) - Install
3512C Engine for 785D Off-Highway Truck/Tractors Engine Design
3512C and 3516C Marine Engines Engine Design
C32 Petroleum Engines Camshaft Position Sensor - Remove and Install
C-9 Industrial Engine Maintenance Interval Schedule
TH48-E80 Petroleum Transmission Power Train Electronic Control System Quick To Neutral Function
TH48-E80 Petroleum Transmission Power Train Electronic Control System Lockup Clutch Disable Function
3500C Marine Engines Engine Design
C27 and C32 Generator Set Engines Speed Control (Switch) - Test
3500 and 3500B High Displacement Engines for Caterpillar Built Machines Auxiliary Water Pump - Assemble
C32 Petroleum Engines Fuel Pressure Sensor - Remove and Install
345C Excavator and 345C MHPU Mobile Hydraulic Power Unit Machine Systems Final Drive - Disassemble
324D, 325D, 326D and 329D Excavators and 329D MHPU Mobile Hydraulic Power Unit Machine Systems Window Wiper Motor - Remove and Install - Lower
3408E and 3412E Engines for Caterpillar Built Machines Cylinder Liner
C32 Petroleum Engines Fuel Temperature Sensor - Remove and Install
324D, 325D, 326D and 329D Excavators and 329D MHPU Mobile Hydraulic Power Unit Machine Systems Actuator Motor (Air Distributor) - Remove and Install
345C MHPU Mobile Hydraulic Power Unit Machine Systems Fuel Tank - Remove
345C MHPU Mobile Hydraulic Power Unit Machine Systems Fuel Tank - Install
2005/10/03 Starting the Engine with Jumper Cables on Machines with an Electric Starter {1000, 7000}
2005/10/03 Caterpillar Warranty Claims on Cylinder Head Valves {1105}
C1.5 and C2.2 Generator Set Engines Engine Enclosure Group - Remove and Install