Coolant Temperature Sensor - Remove and Install
Show/hide table
| NOTICE |
|---|
|
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting, and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids. Refer to Special Publication, NENG2500, "Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Cat products. Dispose of all fluids according to local regulations and mandates. |
Show/hide table
| NOTICE |
|---|
|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Drain the coolant from the cooling system to a level below the coolant temperature sensor into a suitable container for storage or disposal. Refer to Operation and Maintenance Manual, "Cooling System Coolant - Change".
Show/hide table
Illustration 1 g01207715 - Disconnect harness assembly (2).
- Remove coolant temperature sensor (1).
- Remove the O-ring seal from coolant temperature sensor (1).
Show/hide table
| NOTICE |
|---|
|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Install a new O-ring seal on coolant temperature sensor (1).
- Install coolant temperature sensor (1) and tighten to a torque of
20 ± 5 N·m (15 ± 4 lb ft) . - Connect harness assembly (2).
- Fill the cooling system with coolant. Refer to Operation and Maintenance Manual, "Cooling System Coolant - Change".
Show/hide table
| |
| Illustration 2 | g01207715 |
Caterpillar Information System:
345C MHPU Mobile Hydraulic Power Unit Machine Systems Seat - Remove and Install
C32 Petroleum Engines Crankshaft Position Sensor - Remove and Install
345C MHPU Mobile Hydraulic Power Unit Machine Systems Pilot Valve (Travel) - Install
3512C Engine for 785D Off-Highway Truck/Tractors Engine Design
3512C and 3516C Marine Engines Engine Design
C32 Petroleum Engines Camshaft Position Sensor - Remove and Install
C-9 Industrial Engine Maintenance Interval Schedule
TH48-E80 Petroleum Transmission Power Train Electronic Control System Quick To Neutral Function
TH48-E80 Petroleum Transmission Power Train Electronic Control System Lockup Clutch Disable Function
3500C Marine Engines Engine Design
C27 and C32 Generator Set Engines Speed Control (Switch) - Test
793D Off-Highway Truck Power Train Liquid Level Switch (Torque Converter Oil)
C32 Petroleum Engines Engine Oil Pressure Sensor - Remove and Install
3500 and 3500B High Displacement Engines for Caterpillar Built Machines Auxiliary Water Pump - Assemble
C32 Petroleum Engines Fuel Pressure Sensor - Remove and Install
345C Excavator and 345C MHPU Mobile Hydraulic Power Unit Machine Systems Final Drive - Disassemble
324D, 325D, 326D and 329D Excavators and 329D MHPU Mobile Hydraulic Power Unit Machine Systems Window Wiper Motor - Remove and Install - Lower
3408E and 3412E Engines for Caterpillar Built Machines Cylinder Liner
C32 Petroleum Engines Fuel Temperature Sensor - Remove and Install
324D, 325D, 326D and 329D Excavators and 329D MHPU Mobile Hydraulic Power Unit Machine Systems Actuator Motor (Air Distributor) - Remove and Install
345C MHPU Mobile Hydraulic Power Unit Machine Systems Fuel Tank - Remove
345C MHPU Mobile Hydraulic Power Unit Machine Systems Fuel Tank - Install
2005/10/03 Starting the Engine with Jumper Cables on Machines with an Electric Starter {1000, 7000}
2005/10/03 Caterpillar Warranty Claims on Cylinder Head Valves {1105}