Fuel Temperature Sensor - Remove and Install
Removal Procedure
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
Show/hide table
NOTICE |
---|
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids. Refer to Special Publication, NENG2500, "Caterpillar Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Caterpillar products. Dispose of all fluids according to local regulations and mandates. |
- Disconnect the harness assembly from fuel temperature sensor (1) .
Show/hide table
Illustration 1 | g01179612 |
- Remove fuel temperature sensor (2) .
- Inspect the condition of the O-ring seal on fuel temperature sensor (1). Replace the O-ring seal, if necessary.
Installation Procedure
- Install fuel temperature sensor (1). Tighten fuel temperature sensor (1) to a torque of 20 ± 5 N·m (15 ± 4 lb ft).
Show/hide table
Illustration 2 | g01179612 |
- Connect the harness assembly to fuel temperature sensor (1) .
Caterpillar Information System:
C-10 Petroleum Engine Fuel Pressure Sensor - Remove and Install
345D, 349D and 349D2 Excavator Machine System Specifications Ether Starting Aid
C27 and C32 Engines for Caterpillar Built Machines Fuel Dilution of Engine Oil
Vane Type Hydraulic Pumps {5055} Vane Type Hydraulic Pumps {5055}
C15 On-Highway Engine Cylinder Block
C4.4 and C6.6 Engines for Caterpillar Built Machines Electronic Service Tool Will Not Communicate with ECM
C7.1 (Mech) Industrial Engine Glow Plugs
C-10 Petroleum Engine Piston Cooling Jets - Remove and Install
C15 On-Highway Engine Engine Oil Filter Base
C-10 Petroleum Engine Cylinder Head - Install
C-10 Petroleum Engine Cylinder Head - Remove
2005/07/04 A New High Temperature Gasket is Now Used {1057}
C-10 Petroleum Engine Turbocharger Outlet Pressure Sensor - Remove and Install
C6.6 Industrial Engine Connecting Rod
12M Motor Grader Cooling System Coolant Sample (Level 2) - Obtain
C-10 Petroleum Engine Inlet Air Temperature Sensor - Remove and Install
C-10 Petroleum Engine Atmospheric Pressure Sensor - Remove and Install
C15 On-Highway Engine Mounting Bracket (Idler Pulley)
TH48-E80 Petroleum Transmission Transmission Hydraulic Control
C-10 Petroleum Engine Flywheel Housing - Remove and Install
3500 Generator Sets Model View Illustrations
C-10 Petroleum Engine Electronic Control Module - Remove and Install
C3.3 and C4.4 Rental Generator Sets Safety Messages
C13 On-highway Engine Engine Support (Front)