C-10 Petroleum Engine Caterpillar


Atmospheric Pressure Sensor - Remove and Install

Usage:

C-10 Z2B

Removal Procedure


NOTICE

Keep all parts clean from contaminants.

Contaminants may cause rapid wear and shortened component life.





    Illustration 1g01179826

  1. Disconnect the harness assembly from atmospheric pressure sensor (1) .

  1. Remove atmospheric pressure sensor (1) .

  1. Inspect the condition of the O-ring seal on atmospheric pressure sensor (1). Replace the O-ring seal, if necessary.

Installation Procedure


NOTICE

Keep all parts clean from contaminants.

Contaminants may cause rapid wear and shortened component life.





    Illustration 2g01179826

  1. Install atmospheric pressure sensor (1). Tighten atmospheric pressure sensor (1) to a torque of 10 ± 2 N·m (89 ± 18 lb in).

  1. Connect the harness assembly to atmospheric pressure sensor (1) .
Back to top
The names Caterpillar, John Deere, JD, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
CH-Part.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only.