Mounting Bracket (Idler Pulley)
Show/hide table
 | |
| Illustration 1 | g01304203 |
Mounting bracket for the idler pulleys | |
(1) Torque for two bolts ... 50 ± 5 N·m (37 ± 4 lb ft)
Show/hide table
 | |
| Illustration 2 | g01527149 |
Tightening sequence for bolts | |
Tighten the bolt 1 through bolt 5 in the numerical sequence that is shown in Illustration 2 .
Caterpillar Information System:
C-10 Petroleum Engine Atmospheric Pressure Sensor - Remove and Install
C-10 Petroleum Engine Inlet Air Temperature Sensor - Remove and Install
12M Motor Grader Cooling System Coolant Sample (Level 2) - Obtain
C6.6 Industrial Engine Connecting Rod
C-10 Petroleum Engine Turbocharger Outlet Pressure Sensor - Remove and Install
C-10 Petroleum Engine Fuel Temperature Sensor - Remove and Install
C-10 Petroleum Engine Fuel Pressure Sensor - Remove and Install
345D, 349D and 349D2 Excavator Machine System Specifications Ether Starting Aid
C27 and C32 Engines for Caterpillar Built Machines Fuel Dilution of Engine Oil
Vane Type Hydraulic Pumps {5055} Vane Type Hydraulic Pumps {5055}
C15 On-Highway Engine Cylinder Block
C4.4 and C6.6 Engines for Caterpillar Built Machines Electronic Service Tool Will Not Communicate with ECM
TH48-E80 Petroleum Transmission Transmission Hydraulic Control
C-10 Petroleum Engine Flywheel Housing - Remove and Install
3500 Generator Sets Model View Illustrations
C-10 Petroleum Engine Electronic Control Module - Remove and Install
C3.3 and C4.4 Rental Generator Sets Safety Messages
C13 On-highway Engine Engine Support (Front)
C13 On-highway Engine Engine Support (Front)
C15 On-Highway Engine Engine Support (Front)
C15 Generator Set Product Description
C7 and C9 Marine Engines Coolant Level Sensor Circuit - Test
C6.6 Engines for Caterpillar Built Machines Piston and Rings
C13 On-highway Engine Air Lines