Fan Drive - Assemble
Show/hide table
所需工具 | |||
工具 | 零件号 | 零件描述 | 数量 |
A | 1P-0510 | 冲头总成 | 1 |
B | 8T-1807 | 轴承润滑油 | 1 |
Show/hide table
注意 |
---|
保持所有零件清洁无杂质。 杂质会造成快速磨损和缩短部件寿命。 |
- 将工具 (B) 涂敷在轴 (9) 的外侧。
- 使用工具 (A) 和适当的压具。 放置好轴承 (7) 并将其压入挡圈 (8) 中,然后压到轴 (9) 上。
- 将螺栓 (5) 和板 (6) 安装在轴 (9) 上。 用
28 ± 7 N·m (21 ± 5 lb ft) 的扭矩拧紧螺栓 (5)。Show/hide table图 3 g01176090 - 将轴组件 (4)、螺栓 (2) 和垫圈 (3) 安装到风扇驱动装置支架 (1) 上。 用
28 ± 7 N·m (21 ± 5 lb ft) 的扭矩拧紧螺栓 (2)。
Show/hide table
图 1 | g01176172 |
Show/hide table
图 2 | g01176110 |
注: 在将轴承压到轴上前,冷却轴。
结束:
- 安装风扇驱动装置。 请参阅拆解和组装, "风扇驱动装置 - 安装"。
Caterpillar Information System:
3500 Generator Set Engines Fuel Shutoff
C15 and C18 Petroleum Generator Sets Engine Oil and Filter - Change
3500 Locomotive Engines Air Shutoff
2005/07/01 Improved Engine Oil Coolers are Now Used {1378}
C-10 Petroleum Engine Inlet Manifold - Remove
2005/07/11 Improved Engine Oil Coolers are Now Used {1378}
2005/06/27 Improved Engine Oil Coolers are Now Used {1378}
C9 Engine for Caterpillar Built Machines Fan Drive - Disassemble
C9 Engine for Caterpillar Built Machines Fan Drive - Remove
C-10 Petroleum Engine Exhaust Manifold - Remove and Install
C-10 Petroleum Engine Turbocharger - Install
C9 Engine for Caterpillar Built Machines Inlet Air Temperature Sensor - Remove and Install
C9 Engine for Caterpillar Built Machines Fan Drive - Install
C-10 Petroleum Engine Inlet Manifold - Install
3500 Engines with EUI Option Turbocharger
2005/07/04 Improved Fuel Cooler {1712}
C15 On-Highway Engine Engine Design
C9 Engine for Caterpillar Built Machines Electronic Control Module - Remove and Install
C9 Generator Set Sensors and Electrical Components
C9 Engine for Caterpillar Built Machines Electric Starting Motor - Remove and Install
325D and 329D Excavators Hydraulic System Boom Drift Reduction Valve
C280 Marine, Marine Auxiliary, and Petroleum Engines Warranty Information
C13, C15, and C18 Tier 4 Final Engines Fuel Transfer Pump
C9 Engine for Caterpillar Built Machines Alternator - Remove and Install