Inlet Manifold - Remove and Install
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Remove bolts (1) and reposition the fuel filter base.
Show/hide table
Illustration 2 g01166611 - Remove bolts (2) and reposition bracket (3) for the air shutoff, if necessary.
Show/hide table
Illustration 3 g01166620 - Remove bolts (4) and bolts (6) from inlet manifold (5).
- Remove inlet manifold (5) and the O-ring seals.
Show/hide table
Illustration 1 | g01166543 |
Typical Example |
- Install the O-ring seals on inlet manifold (5).
- Position inlet manifold (5) on the engine.
- Install bolts (4) and bolts (6).
Show/hide table
Illustration 5 g01166611 - Position bracket (3) for the air shutoff and install bolts (2), if necessary.
Show/hide table
Illustration 6 g01166543 Typical Example - Position the fuel filter base and install bolts (1).
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
Show/hide table
Illustration 4 | g01166620 |
Caterpillar Information System:
C4.4 Marine Generator Set Engines Cylinder Head - Install
3500B and 3500C Generator Set Engines Prelubrication System
3500B and 3500C Generator Set Engines Injector Solenoids
3500B and 3500C Generator Set Engines Ether Injection System
3500B and 3500C Generator Set Engines Engine Speed/Timing Sensor
3500B and 3500C Generator Set Engines Engine Sensor Open/Short Test
3500B and 3500C Generator Set Engines Emergency Stop Switch
3500B and 3500C Generator Set Engines Electrical Power Supply
C4.4 Marine Generator Set Engines Heat Exchanger - Assemble
C4.4 Marine Generator Set Engines Heat Exchanger - Disassemble
C4.4 Marine Generator Set Engines Heat Exchanger - Install
TH48-E80 Petroleum Transmission Fire Prevention and Explosion Prevention
3500B and 3500C Generator Set Engines Speed Control
C4.4 Marine Generator Set Engines Housing (Front) - Install
C4.4 Marine Generator Set Engines Air Shutoff - Remove and Install
C4.4 Marine Generator Set Engines Housing (Front) - Remove
3500B and 3500C Generator Set Engines Starting Motor System
3500B and 3500C Generator Set Engines Analog Sensor - Calibrate
C13 and C15 On-Highway Engines Belts - Inspect/Adjust/Replace
C7 On-highway Engine Turbocharger
CX38-P892 Well Servicing Transmission General Hazard Information
C4.4 Marine Generator Set Engines Engine Oil Pan - Remove and Install
G3400 Engines (EIS) Programmable Parameters
C13 and C15 On-Highway Engines Engine Oil and Filter - Change