Crankshaft Wear Sleeve (Rear) - Remove
Show/hide table
Required Tools | |||
Tool | Part Number | Part Description | Qty |
A | 5P-7338 | Distorter Ring | 1 |
B | 5P-7312 | Seal Distorter | 1 |
Start By:
- Remove the crankshaft rear seal. Refer to Disassembly and Assembly, "Crankshaft Rear Seal - Remove".
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Install Tooling (A) in the bore of the rear housing.
- Install Tooling (B) between Tooling (A) and the crankshaft wear sleeve. Turn Tooling (B) until the edge of Tooling (B) makes a crease in the crankshaft wear sleeve. Make a crease in the crankshaft wear sleeve at two other locations around the crankshaft wear sleeve until the crankshaft wear sleeve is loose.
- Remove Tooling (B), Tooling (A), and the crankshaft wear sleeve from the end of the crankshaft.
- Remove any sealant from the crankshaft.
Note: Wear sleeves are not installed at the factory.
Caterpillar Information System:
C3.3 and C4.4 Generator Sets Crankshaft Rear Seal - Install
C7 On-highway Engine Belt Tensioner
3406C Generator Sets Cold Weather Starting
C2.2 Engine Cylinder Head - Inspect
C3.3 and C4.4 Generator Sets Crankshaft Rear Seal - Remove
C7 On-highway Engine Belt Tensioner
2006/10/30 Using Injector Trim Files {1251, 7620}
2006/10/30 Using Injector Trim Files {1290, 7620}
C2.2 Engine Engine Valve Lash - Inspect/Adjust
C2.2 Engine Fuel Injection Timing - Check
C2.2 Engine and C1.5 Generator Set Glow Plugs - Test
2005/10/10 A New Fuel Level Switch Is Now Being Used {1435, 7481}
C4.4 Marine Generator Set Engines Crankshaft Wear Sleeve (Rear) - Install
C2.2 Engine Glow Plugs - Test
C4.4 Marine Generator Set Engines Flywheel Housing - Remove and Install
C4.4 Marine Generator Set Engines Crankshaft Pulley - Remove and Install
3500 Petroleum Engines and Petroleum Generator Sets Monitoring System
C2.2 Engine Engine Design
C2.2 Engine General Information
3500 Petroleum Engines and Petroleum Generator Sets Cold Weather Starting
C3.3 and C4.4 Generator Sets Crankshaft Front Seal - Remove
C2.2 Engine Basic Engine
C3.3 and C4.4 Generator Sets Crankshaft Front Seal - Install
C2.2 Engine Electrical System