Cylinder Head - Inspect
Show/hide table
Required Tools | ||
---|---|---|
Part Number | Part Name | Qty |
8S-6691 | Cylinder Head Stand Set | 1 |
Show/hide table
Illustration 1 | g00907444 |
Bolt tightening sequence for the C2.2/3024C engine |
- Remove the bolts in the cylinder head in the reverse sequence that is shown in Illustration 1.
Remove the cylinder head from the engine.
- Clean the cylinder head thoroughly. Make sure that the contact surface of the cylinder head and the contact surface of the cylinder block are clean, smooth, and flat.
- Inspect the bottom surface of the cylinder head for pitting, corrosion, and cracks. Inspect the area around the valve seats and the holes for the fuel injection nozzles.
Show/hide table
Illustration 2 g00842292 Typical example - Put cylinder head (1) on the 8S-6691 Cylinder Head Stand Set (2).
Show/hide table
Illustration 3 g00907448 Typical example - Use a straight edge and a feeler gauge to check the six positions of the cylinder head for distortion. Refer to Specifications, "Cylinder Head" for the requirements of flatness.
Caterpillar Information System:
C3.3 and C4.4 Generator Sets Crankshaft Rear Seal - Remove
C7 On-highway Engine Belt Tensioner
2006/10/30 Using Injector Trim Files {1251, 7620}
2006/10/30 Using Injector Trim Files {1290, 7620}
C2.2 Engine Engine Valve Lash - Inspect/Adjust
C2.2 Engine Fuel Injection Timing - Check
C2.2 Engine and C1.5 Generator Set Glow Plugs - Test
2005/10/10 A New Fuel Level Switch Is Now Being Used {1435, 7481}
C2.2 Engine and C1.5 Generator Set Cylinder Head - Inspect
C2.2 Engine Glow Plugs
C2.2 Engine Engine Oil Pressure Switch
C2.2 Engine and C1.5 Generator Set Piston Ring Groove - Inspect
3406C Generator Sets Cold Weather Starting
C7 On-highway Engine Belt Tensioner
C3.3 and C4.4 Generator Sets Crankshaft Rear Seal - Install
C4.4 Marine Generator Set Engines Crankshaft Wear Sleeve (Rear) - Remove
C4.4 Marine Generator Set Engines Crankshaft Wear Sleeve (Rear) - Install
C2.2 Engine Glow Plugs - Test
C4.4 Marine Generator Set Engines Flywheel Housing - Remove and Install
C4.4 Marine Generator Set Engines Crankshaft Pulley - Remove and Install
3500 Petroleum Engines and Petroleum Generator Sets Monitoring System
C2.2 Engine Engine Design
C2.2 Engine General Information
3500 Petroleum Engines and Petroleum Generator Sets Cold Weather Starting