Belt Tensioner
Show/hide table
 | |
| Illustration 1 | g01214177 |
(1) Minimum travel ... 52 degrees
(2) The torque for the spring is 59.9 ± 6.0 N·m (44 ± 4 lb ft) at 35 degrees from the released position.
Caterpillar Information System:
2006/10/30 Using Injector Trim Files {1251, 7620}
2006/10/30 Using Injector Trim Files {1290, 7620}
C2.2 Engine Engine Valve Lash - Inspect/Adjust
C2.2 Engine Fuel Injection Timing - Check
C2.2 Engine and C1.5 Generator Set Glow Plugs - Test
2005/10/10 A New Fuel Level Switch Is Now Being Used {1435, 7481}
C2.2 Engine and C1.5 Generator Set Cylinder Head - Inspect
C2.2 Engine Glow Plugs
C2.2 Engine Engine Oil Pressure Switch
C2.2 Engine and C1.5 Generator Set Piston Ring Groove - Inspect
C2.2 Engine Gear Group (Front)
C2.2 Engine Piston and Rings
C3.3 and C4.4 Generator Sets Crankshaft Rear Seal - Remove
C2.2 Engine Cylinder Head - Inspect
3406C Generator Sets Cold Weather Starting
C7 On-highway Engine Belt Tensioner
C3.3 and C4.4 Generator Sets Crankshaft Rear Seal - Install
C4.4 Marine Generator Set Engines Crankshaft Wear Sleeve (Rear) - Remove
C4.4 Marine Generator Set Engines Crankshaft Wear Sleeve (Rear) - Install
C2.2 Engine Glow Plugs - Test
C4.4 Marine Generator Set Engines Flywheel Housing - Remove and Install
C4.4 Marine Generator Set Engines Crankshaft Pulley - Remove and Install
3500 Petroleum Engines and Petroleum Generator Sets Monitoring System
C2.2 Engine Engine Design