Removal Procedure
Required Tools     | |||
Tool     | Part Number     | Part Description     | Qty     |
A     | 227-4390     | E12 Torx Socket     | 1     |
Start By:
- Remove the flywheel. Refer to Disassembly and Assembly, "Flywheel - Remove".
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
NOTICE |
---|
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting, and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids. Refer to Special Publication, NENG2500, "Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Cat products. Dispose of all fluids according to local regulations and mandates. |
Note: The crankshaft rear seal and the housing are manufactured as a one-piece assembly. The assembly is not serviceable. If the crankshaft rear seal is removed, the assembly must be replaced.
- Use Tooling (A) in order to remove torx screws (1) from crankshaft rear seal (2) .
Illustration 1 | g01269512 |
Typical example |
- Remove crankshaft rear seal (2) from the cylinder block. Discard the crankshaft rear seal.