Belt Tensioner
Show/hide table
 | |
| Illustration 1 | g01524313 |
(1) Spring force at assembly is 59.9 ± 6.0 N·m (44 ± 4 lb ft) at 35 degrees from the free arm position.
(A) Travel for the arm ... 52 degrees
Caterpillar Information System:
3406C Generator Sets Cold Weather Starting
C2.2 Engine Cylinder Head - Inspect
C3.3 and C4.4 Generator Sets Crankshaft Rear Seal - Remove
C7 On-highway Engine Belt Tensioner
2006/10/30 Using Injector Trim Files {1251, 7620}
2006/10/30 Using Injector Trim Files {1290, 7620}
C2.2 Engine Engine Valve Lash - Inspect/Adjust
C2.2 Engine Fuel Injection Timing - Check
C2.2 Engine and C1.5 Generator Set Glow Plugs - Test
2005/10/10 A New Fuel Level Switch Is Now Being Used {1435, 7481}
C2.2 Engine and C1.5 Generator Set Cylinder Head - Inspect
C2.2 Engine Glow Plugs
C3.3 and C4.4 Generator Sets Crankshaft Rear Seal - Install
C4.4 Marine Generator Set Engines Crankshaft Wear Sleeve (Rear) - Remove
C4.4 Marine Generator Set Engines Crankshaft Wear Sleeve (Rear) - Install
C2.2 Engine Glow Plugs - Test
C4.4 Marine Generator Set Engines Flywheel Housing - Remove and Install
C4.4 Marine Generator Set Engines Crankshaft Pulley - Remove and Install
3500 Petroleum Engines and Petroleum Generator Sets Monitoring System
C2.2 Engine Engine Design
C2.2 Engine General Information
3500 Petroleum Engines and Petroleum Generator Sets Cold Weather Starting
C3.3 and C4.4 Generator Sets Crankshaft Front Seal - Remove
C2.2 Engine Basic Engine