Crankshaft Front Seal - Install
Show/hide table
| Required Tools | |||
| Tool | Part Number | Part Description | Qty |
| A | 9U-6210 | Front Seal Installer | 1 |
Show/hide table
| NOTICE |
|---|
|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Clean the housing for the crankshaft front seal and inspect the housing for damage.
- Lubricate the lip of the crankshaft front seal with clean engine oil.
Note: The installation sleeve is supplied with a new crankshaft front seal. Do Not separate the installation sleeve from the crankshaft front seal.
Show/hide table
Illustration 1 g00952168 - Assemble Tooling (A).
- Place crankshaft front seal assembly (1) into the front housing.
Show/hide table
NOTICE Ensure that the lip of the crankshaft front seal that is spring loaded is facing toward the inside of the front housing and that it is square with the bore of the housing for the crankshaft front seal.
- Use Tooling (A) to install crankshaft front seal assembly (1). The crankshaft front seal must contact the bottom face of the front housing.
- Remove Tooling (A) from the crankshaft. Turn the installation sleeve counterclockwise and pull in order to remove the installation sleeve from the crankshaft front seal.
- Apply clean engine oil on the area of the crankshaft pulley that will be in contact with the crankshaft front seal.
End By:
- Install the crankshaft pulley. Refer to Disassembly and Assembly, "Crankshaft Pulley - Remove and Install".
Caterpillar Information System:
C2.2 Engine Basic Engine
C3.3 and C4.4 Generator Sets Crankshaft Front Seal - Remove
3500 Petroleum Engines and Petroleum Generator Sets Cold Weather Starting
C2.2 Engine General Information
C2.2 Engine Engine Design
3500 Petroleum Engines and Petroleum Generator Sets Monitoring System
C4.4 Marine Generator Set Engines Crankshaft Pulley - Remove and Install
C4.4 Marine Generator Set Engines Flywheel Housing - Remove and Install
C2.2 Engine Glow Plugs - Test
C4.4 Marine Generator Set Engines Crankshaft Wear Sleeve (Rear) - Install
C4.4 Marine Generator Set Engines Crankshaft Wear Sleeve (Rear) - Remove
C3.3 and C4.4 Generator Sets Crankshaft Rear Seal - Install
C2.2 Engine Electrical System
C2.2 Engine Troubleshooting
3500 Petroleum Engines and Petroleum Generator Sets Cooling System Coolant (DEAC) - Change
3500 Petroleum Engines and Petroleum Generator Sets Cooling System Coolant (ELC) - Change
C4.4 Marine Generator Set Engines Front Cover - Remove and Install
C15 and C18 Petroleum Generator Sets After Stopping Engine
C32 Petroleum Engines Fuel System - Prime
3500 Petroleum Engines and Petroleum Generator Sets Emergency Stopping
C6.6 Industrial Engine High Pressure Fuel Lines
C7 On-highway Engine Air Inlet Elbow
TH48-E80 Petroleum Transmission Oil Filter (Torque Converter, Transmission) - Replace
3612 and 3616 Engines Fuel Pressure