Removal Procedure
Note: Cleanliness is an important factor. Before the disassembly procedure, the exterior of the component should be thoroughly cleaned. This will help to prevent dirt from entering the internal mechanism.
NOTICE |
---|
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids. Refer to Special Publication, NENG2500, "Caterpillar Tools and Shop Products Guide" for tools and supplies suitable to collect and contain fluids on Caterpillar products. Dispose of all fluids according to local regulations and mandates. |
Personal injury can result from hydraulic oil pressure and hot oil. Hydraulic oil pressure can remain in the hydraulic system after the engine has been stopped. Serious injury can be caused if this pressure is not released before any service is done on the hydraulic system. Make sure all of the work tools have been lowered to the ground, and the oil is cool before removing any components or lines. Remove the oil filler cap only when the engine is stopped, and the filler cap is cool enough to touch with your bare hand. |
- Remove the bolt and clips (2) that hold hose assembly (3) in position.
Illustration 1 | g00726700 |
- Disconnect hose assemblies (1) and (3) from the lift cylinder.
- Fasten a hoist to lift cylinder (6), as shown.
Illustration 2 | g00726701 |
- Remove the four nuts and bolts (4). Remove the shims and cap (5) from the rod assembly.
- Remove the bolt and retainer (8) from pin (7). Remove pin (7), the spacers and lift cylinder (6). The weight of the lift cylinder is 65 kg (143.0 lb).
Illustration 3 | g00726703 |