Bulldozer Lift Cylinder - Install
Installation Procedure
Note: Cleanliness is an important factor. Before assembly, all parts should be thoroughly cleaned in cleaning fluid. Allow the parts to air dry. Wiping cloths or rags should not be used to dry parts. Lint may be deposited on the parts which may cause later trouble. Inspect all parts. If any parts are worn or damaged, use new parts for replacement.
- Fasten a hoist to lift cylinder (6), as shown. Put the lift cylinder into position in the support assembly with the two spacers and install pin (7) .
Show/hide table
Illustration 1 | g00726703 |
- Install retainer (8) and the bolt that holds pin (7) in place.
- Connect hose assemblies (1) and (3) to the lift cylinder.
Show/hide table
Illustration 2 | g00726700 |
- Install clips (2) and the bolt in order to hold hose assembly (3) in position on the lift cylinder.
- Start the machine and move the lift cylinder until the rod assembly makes contact with the trunnion ball on the bulldozer blade.
- Put cap (5) and the shims into position on the rod assembly. Install four bolts (4) and the nuts.
Show/hide table
Illustration 3 | g00726701 |
Note: Install an equal amount of shims on each side of the cap in order to obtain a 0.3 mm (.010 inch) to 0.8 mm (.030 inch) clearance between the cap and the trunnion ball.
- Fill the implement hydraulic system. Refer to the appropriate Operation and Maintenance Manual for the correct procedure.
Caterpillar Information System:
D6M Track-Type Tractor Machine Systems Bulldozer Control Valve - Remove
D6M Track-Type Tractor Machine Systems Bulldozer Control Valve - Install
D6M Track-Type Tractor Machine Systems Bulldozer Control Valve - Disassemble
D6M Track-Type Tractor Machine Systems Bulldozer Control Valve - Assemble
D6M Track-Type Tractor Machine Systems Bulldozer C-Frame - Remove and Install
D6M Track-Type Tractor Machine Systems Bulldozer Angle Cylinder - Remove
D6M Track-Type Tractor Machine Systems Bulldozer Angle Cylinder - Install
D6M Track-Type Tractor Machine Systems Bulldozer - Remove
D6M Track-Type Tractor Machine Systems Bulldozer - Install
D6M Track-Type Tractor Machine Systems Bulldozer - Disassemble
D6M Track-Type Tractor Machine Systems Bulldozer - Assemble
D6M Track-Type Tractor Machine Systems Bulldozer (VPAT) - Remove
D6M Track-Type Tractor Machine Systems Bulldozer Lift Cylinder - Remove
D6M Track-Type Tractor Machine Systems Bulldozer Lift Cylinder Mounts - Remove and Install
D6M Track-Type Tractor Machine Systems Bulldozer Tilt Cylinder - Install
D6M Track-Type Tractor Machine Systems Bulldozer Tilt Cylinder - Remove
D8R Track-Type Tractor Battery - Inspect
D6M Track-Type Tractor Machine Systems Cab - Install
D6M Track-Type Tractor Machine Systems Cab - Remove
D6M Track-Type Tractor Machine Systems Implement Pump - Assemble
D6M Track-Type Tractor Machine Systems Implement Pump - Disassemble
D6M Track-Type Tractor Machine Systems Implement Pump - Install
D6M Track-Type Tractor Machine Systems Implement Pump - Remove
D6M Track-Type Tractor Machine Systems Fuel Tank - Install