Engine Oil Cooler - Install
Show/hide table
| 所需工具 | |||
|---|---|---|---|
| 工具 | 零件号 | 零件说明 | 数量 |
| A | 1U-6396 | O 形圈组装固定胶 | - |
Show/hide table
| 注意 |
|---|
|
保持所有零件清洁无杂质。 杂质会造成快速磨损和缩短部件寿命。 |
- 将 O 形密封圈 (11) 安装在机油冷却器底盖 (6) 上。 将工具 (A) 涂抹在 O 形密封圈上。 将整体式密封 (7) 安装在机油冷却器底盖 (6) 上。 将机油冷却器底盖安置在水泵上并安装螺栓 (12)。
- 将 O 形密封圈 (10) 安装在发动机机油滤清器底座上。
- 朝着发动机前方滑动芯组件 (5)。 将芯组件转动到位。 安装螺栓 (9)。
- 将 O 形密封圈 (8) 安装在出口盖 (3) 上。 将工具 (A) 涂抹在 O 形密封圈上。 将整体式密封 (2) 安装在出口盖 (3) 上。 将出口盖 (3) 安装在芯组件上并安装螺栓 (1)。
- 安装螺栓 (4)。
- 加注冷却系统。 请参考操作和保养手册, "冷却系统冷却液 - 更换"。
Show/hide table
| |
| 图 1 | g01092858 |
Caterpillar Information System:
C15 and C18 Industrial Engines Engine Oil Cooler - Remove
3412E, C30 and C32 Marine Engines Engine Oil Pump - Disassemble
3412E, C30 and C32 Marine Engines Engine Oil Pump - Remove
C15 and C18 Industrial Engines Engine Oil Filter Base - Install
C15 and C18 Industrial Engines Engine Oil Filter Base - Remove
G3612 and G3616 Engines Safety Messages
C15 and C18 Industrial Engines Electric Starting Motor - Remove and Install
3500B and 3500C Marine Engines Turbocharger Inlet Pressure Sensor
3516B and 3516B High Displacement Engines for 994D and 994F Wheel Loaders Crankcase Pressure Sensor
3500 and 3500B Engines Electrical System
C15 and C18 Industrial Engines Alternator - Remove and Install
G3500 Generator Sets Cooling System Coolant (NGEC) - Change
2004/08/01 A New Exhaust Seal is Used {1059}
C15 and C18 Industrial Engines Water Pump - Remove
C15 and C18 Industrial Engines Water Pump - Install
3412E, C30 and C32 Marine Engines Engine Oil Pump - Assemble
3508B, 3512B, and 3516B High Displacement Generator Sets Walk-Around Inspection
3508B Industrial Engines Engine Oil Temperature Sensor
3412E, C30 and C32 Marine Engines Engine Oil Pump - Install
2004/08/01 An Improved Injection Actuation Pressure Sensor Is Now Used {1925}
3500 Engines for Caterpillar Built Generator Sets Prelube Pressure Switch
EMCP3 Component Location
EMCP3 Digital Input Programming
EMCP3 Spare Analog Input Programming