Engine Oil Pump - Disassemble
Show/hide table
Required Tools | |||
---|---|---|---|
Tool | Part Number | Part Description | Qty |
A | 1P-2321 | Puller Group | 1 |
B | 1P-0510 | Driver Group | 1 |
Start By:
- Remove the engine oil pump. Refer to Disassembly and Assembly, "Engine Oil Pump - Remove".
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Remove bolt (1).
- Use Tooling (A) to remove gear (2).
Show/hide table
Illustration 2 g00573424 - Remove key (3) from the shaft.
Show/hide table
Illustration 3 g01092829 Show/hide tablePersonal injury can result from parts and/or covers under spring pressure.
Spring force will be released when covers are removed.
Be prepared to hold spring loaded covers as the bolts are loosened.
- Remove retainer (7). Remove spring (6) and plunger (5) from the oil pump housing.
- Remove cover (4).
Show/hide table
Illustration 4 g01092847 - Use Tooling (B) to remove bearings (8) from cover (4), if the cover is equipped with bearings.
Show/hide table
Illustration 5 g01092850 - Remove shaft assemblies (9) from the oil pump body.
Show/hide table
Illustration 6 g01092852 - Use Tooling (B) to remove bearings (10) from the oil pump body.
Show/hide table
Illustration 1 | g00573401 |
Caterpillar Information System:
3412E, C30 and C32 Marine Engines Engine Oil Pump - Remove
C15 and C18 Industrial Engines Engine Oil Filter Base - Install
C15 and C18 Industrial Engines Engine Oil Filter Base - Remove
G3612 and G3616 Engines Safety Messages
C15 and C18 Industrial Engines Electric Starting Motor - Remove and Install
3500B and 3500C Marine Engines Turbocharger Inlet Pressure Sensor
3516B and 3516B High Displacement Engines for 994D and 994F Wheel Loaders Crankcase Pressure Sensor
3500 and 3500B Engines Electrical System
C15 and C18 Industrial Engines Alternator - Remove and Install
G3500 Generator Sets Cooling System Coolant (NGEC) - Change
C13, C15, and C18 Generator Set Engines Speed Control (Switch) - Test
C15 and C18 Industrial Engines Camshaft - Remove
C15 and C18 Industrial Engines Engine Oil Cooler - Remove
C15 and C18 Industrial Engines Engine Oil Cooler - Install
2004/08/01 A New Exhaust Seal is Used {1059}
C15 and C18 Industrial Engines Water Pump - Remove
C15 and C18 Industrial Engines Water Pump - Install
3412E, C30 and C32 Marine Engines Engine Oil Pump - Assemble
3508B, 3512B, and 3516B High Displacement Generator Sets Walk-Around Inspection
3508B Industrial Engines Engine Oil Temperature Sensor
3412E, C30 and C32 Marine Engines Engine Oil Pump - Install
2004/08/01 An Improved Injection Actuation Pressure Sensor Is Now Used {1925}
3500 Engines for Caterpillar Built Generator Sets Prelube Pressure Switch
EMCP3 Component Location