Engine Oil Pump - Remove
Start By:
- Remove the engine oil pan. Refer to Disassembly and Assembly, "Engine Oil Pan - Remove and Install".
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
Show/hide table
NOTICE |
---|
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting, and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids. Refer to Special Publication, NENG2500, "Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Cat products. Dispose of all fluids according to local regulations and mandates. |
- Remove bolts (4).
- Remove the suction bell and tube (3).
- Remove bolt (5).
- Remove tube assembly (6).
- Remove bolts (1).
- Remove engine oil pump (2).
Show/hide table
Illustration 1 | g01092786 |
Caterpillar Information System:
C15 and C18 Industrial Engines Engine Oil Filter Base - Install
C15 and C18 Industrial Engines Engine Oil Filter Base - Remove
G3612 and G3616 Engines Safety Messages
C15 and C18 Industrial Engines Electric Starting Motor - Remove and Install
3500B and 3500C Marine Engines Turbocharger Inlet Pressure Sensor
3516B and 3516B High Displacement Engines for 994D and 994F Wheel Loaders Crankcase Pressure Sensor
3500 and 3500B Engines Electrical System
C15 and C18 Industrial Engines Alternator - Remove and Install
G3500 Generator Sets Cooling System Coolant (NGEC) - Change
C13, C15, and C18 Generator Set Engines Speed Control (Switch) - Test
C15 and C18 Industrial Engines Camshaft - Remove
C15 and C18 Industrial Engines Camshaft - Install
3412E, C30 and C32 Marine Engines Engine Oil Pump - Disassemble
C15 and C18 Industrial Engines Engine Oil Cooler - Remove
C15 and C18 Industrial Engines Engine Oil Cooler - Install
2004/08/01 A New Exhaust Seal is Used {1059}
C15 and C18 Industrial Engines Water Pump - Remove
C15 and C18 Industrial Engines Water Pump - Install
3412E, C30 and C32 Marine Engines Engine Oil Pump - Assemble
3508B, 3512B, and 3516B High Displacement Generator Sets Walk-Around Inspection
3508B Industrial Engines Engine Oil Temperature Sensor
3412E, C30 and C32 Marine Engines Engine Oil Pump - Install
2004/08/01 An Improved Injection Actuation Pressure Sensor Is Now Used {1925}
3500 Engines for Caterpillar Built Generator Sets Prelube Pressure Switch