Engine Oil Filter Base - Install
Show/hide table
注意 |
---|
保持所有零件清洁无杂质。 杂质会造成快速磨损和缩短部件寿命。 |
- 将 O 形密封圈 (4) 安装到机油滤清器底座 (3) 上。
- 将发动机机油滤清器底座 (3) 安置在发动机上,然后安装螺栓 (1) 和螺栓 (5)。
- 连接软管组件 (2)。
- 安装发动机机油滤清器 (6)。 请遵守发动机机油滤清器上有关正确安装步骤的说明。 请勿过分拧紧发动机机油滤清器。
- 向润滑系统中加注发动机油。 请参阅操作和保养手册, "加注容量",以了解发动机的润滑系统容量。
Show/hide table
图 1 | g01092780 |
结束:
- 安装机油冷却器。 请参阅拆解和组装, "发动机机油冷却器 - 安装"。
Caterpillar Information System:
C15 and C18 Industrial Engines Engine Oil Filter Base - Remove
G3612 and G3616 Engines Safety Messages
C15 and C18 Industrial Engines Electric Starting Motor - Remove and Install
3500B and 3500C Marine Engines Turbocharger Inlet Pressure Sensor
3516B and 3516B High Displacement Engines for 994D and 994F Wheel Loaders Crankcase Pressure Sensor
3500 and 3500B Engines Electrical System
C15 and C18 Industrial Engines Alternator - Remove and Install
G3500 Generator Sets Cooling System Coolant (NGEC) - Change
C13, C15, and C18 Generator Set Engines Speed Control (Switch) - Test
C15 and C18 Industrial Engines Camshaft - Remove
C15 and C18 Industrial Engines Camshaft - Install
G3500 Engines Starting the Engine
3412E, C30 and C32 Marine Engines Engine Oil Pump - Remove
3412E, C30 and C32 Marine Engines Engine Oil Pump - Disassemble
C15 and C18 Industrial Engines Engine Oil Cooler - Remove
C15 and C18 Industrial Engines Engine Oil Cooler - Install
2004/08/01 A New Exhaust Seal is Used {1059}
C15 and C18 Industrial Engines Water Pump - Remove
C15 and C18 Industrial Engines Water Pump - Install
3412E, C30 and C32 Marine Engines Engine Oil Pump - Assemble
3508B, 3512B, and 3516B High Displacement Generator Sets Walk-Around Inspection
3508B Industrial Engines Engine Oil Temperature Sensor
3412E, C30 and C32 Marine Engines Engine Oil Pump - Install
2004/08/01 An Improved Injection Actuation Pressure Sensor Is Now Used {1925}