Flywheel
Show/hide table
 | |
| Illustration 1 | g01095776 |
(2) Ring gear | |
Note: Refer to the System Operation, Testing & Adjusting, "Flywheel Runout" for the correct method of flywheel inspection.
(1) Apply engine oil, molybdenum disulfide, or a graphite based lubricant to the threads of the bolts. Tighten the bolts to the following torque. ... 270 ± 40 N·m (200 ± 30 lb ft)
Caterpillar Information System:
C9.3 Engine for Caterpillar Built Machines Connecting Rod
3126B Industrial Engines Injector Solenoid Circuit - Test
2004/06/21 Information Release Memo, HOS04-02, "XT-6 Hose and Couplings to XT-6 ES Components" Is Available {5057}
C9 Marine Engines and C9 Marine Generator Sets Fuel Filter Base
3406E, C-10 and C-12 On-highway Engines Electronic Service Tools
3126B Industrial Engines Engine Temperature Sensor Open or Short Circuit - Test
C11 and C13 Industrial Engines Speed/Timing Sensor
C7 Urban Transit Bus Engines Sensors and Electrical Components
C7 Urban Transit Bus Engines Fuel System Primary Filter - Replace
3126E and 3126B Commercial and Truck Engines Product Storage
3406E, C-10 and C-12 On-highway Engines Vehicle Speed Circuit - Calibrate
2004/08/01 Caterpillar Remanufactured Products Group Announces the Introduction of the Help Line Reference Tool {1000}
C13, C15, and C18 Generator Set Engines Flywheel
C13, C15, and C18 Tier 4 Final Engines Flywheel
C15 and C18 Industrial Engines Flywheel
C9.3 Engine for Caterpillar Built Machines Piston and Rings
C15 Petroleum Generator Set Engines Engine Design
3408E and 3412E Engines for Caterpillar Built Machines Belt Tension Chart
3126B Industrial Engines Excessive White Smoke
3406E, C-10 and C-12 On-highway Engines 0091-13 Throttle Position out of calibration (28)
3126B Industrial Engines Low Power/Poor or No Response to Throttle
C15 and C18 Industrial Engines Turbocharger
2004/06/01 New Seal for the Front Housing {1151, 1207}
C15 and C18 Industrial Engines Turbocharger