Connecting Rod
Show/hide table
Illustration 1 | g06347740 |
Show/hide table
Item | Qty | Part | Specification Description |
---|---|---|---|
1 | - | - | The bearing joint must be within ± 5 degrees of either location. |
2 | 2 | 160-8197 Bolt | Use the following procedure to tighten the bolts:
1. Tighten the bolt to 2. Again, tighten the bolt to a torque angle of 90 ± 5 degrees. |
A | - | - | Bore in the bearing for the piston pin is |
B | - | - | The connecting rod may be heated from |
C | - | - | Bore in the connecting rod for the piston pin bearing is |
D | - | - | Distance between the center of the bearing is |
E | - | - | Bore in the connecting rod for the crankshaft bearing is |
Lubricate the rod and piston group with clean engine oil before you insert the rod and piston group into the block. |
Caterpillar Information System:
3126B Industrial Engines Injector Solenoid Circuit - Test
2004/06/21 Information Release Memo, HOS04-02, "XT-6 Hose and Couplings to XT-6 ES Components" Is Available {5057}
C9 Marine Engines and C9 Marine Generator Sets Fuel Filter Base
3406E, C-10 and C-12 On-highway Engines Electronic Service Tools
3126B Industrial Engines Engine Temperature Sensor Open or Short Circuit - Test
C11 and C13 Industrial Engines Speed/Timing Sensor
C7 Urban Transit Bus Engines Sensors and Electrical Components
C7 Urban Transit Bus Engines Fuel System Primary Filter - Replace
3126E and 3126B Commercial and Truck Engines Product Storage
3406E, C-10 and C-12 On-highway Engines Vehicle Speed Circuit - Calibrate
2004/08/01 Caterpillar Remanufactured Products Group Announces the Introduction of the Help Line Reference Tool {1000}
2004/07/01 Caterpillar Remanufactured Products Group Announces the Introduction of the Help Line Reference Tool {1000}
3408B and 3408C Industrial and Marine Engines Flywheel
C13, C15, and C18 Generator Set Engines Flywheel
C13, C15, and C18 Tier 4 Final Engines Flywheel
C15 and C18 Industrial Engines Flywheel
C9.3 Engine for Caterpillar Built Machines Piston and Rings
C15 Petroleum Generator Set Engines Engine Design
3408E and 3412E Engines for Caterpillar Built Machines Belt Tension Chart
3126B Industrial Engines Excessive White Smoke
3406E, C-10 and C-12 On-highway Engines 0091-13 Throttle Position out of calibration (28)
3126B Industrial Engines Low Power/Poor or No Response to Throttle
C15 and C18 Industrial Engines Turbocharger
2004/06/01 New Seal for the Front Housing {1151, 1207}