Customer Specified Parameters Table
Show/hide table
| 用户指定参数表 | ||
|---|---|---|
| "参数" | 可选范围或选项 | 默认值 |
| "选取的发动机额定值" | ||
| "额定编号" | 取决于发动机功率 | 不可用 |
| "ECM 标识参数" | ||
| "车辆识别号" | 17 位数字 可用字符取决于维修工具。 |
全部为零 |
| "安全访问参数" | ||
| "ECM 无线通讯启用" | "是" "否" |
"否" |
| "车速参数" | ||
| "车速标定" | 2485 到 40705 PPKM (4000 到 65535 PPM) |
8696 PPKM (14000 PPM) |
| "车速限制" | 48 到 204 km/h (30 到 127 mph) |
204 km/h (127 mph) |
| "VSL 保护" | 1300 到 2120 rpm | 2120 rpm |
| "转速表标定" | 12.0 到 500.0 个脉冲 / 转 | 113.0 个脉冲 / 转 |
| "软车速限制" | "是" "否" |
"否" |
| "巡航控制参数" | ||
| "巡航控制车速设定下限" | 24 到 204 km/h (15 到 127 mph) |
204 km/h (127 mph) |
| "巡航控制车速设定上限" | 48 到 204 km/h (30 到 127 mph) |
204 km/h (127 mph) |
| "发动机减速器模式" | "滑行" "锁定" "手动" |
"滑行" |
| "发动机减速器最低 VSL 类型" | "硬性限制" "柔性限制" |
"硬性限制" |
| "发动机减速器最低车速" | 0 到 204 km/h (0 到 127 mph) |
0 km/h (0 mph) |
| "巡航自动减速器" | 0 到 16 km/h (0 到 10 mph) |
0 km/h (0 mph) |
| "巡航增量中的自动减速器" | 0 到 8 km/h (0 到 5 mph) |
3 km/h (2 mph) |
| "巡航 / 怠速 /PTO 开关配置" | "设定/加速" "设定/减速" |
"设定/加速" |
| "软巡航控制" | "是" "否" |
"是" |
| "怠速参数" | ||
| "怠速车速限制" | 2 到 24 km/h (1 到 15 mph) |
2 km/h (1 mph) |
| "怠速转速限制" | 600 rpm 到 2120 rpm | 2120 rpm |
| "怠速 /PTO 转速加速率" | 5 到 1000 rpm/ 秒 | 50 rpm/ 秒 |
| "怠速 /PTO 突变转速" | 5 到 500 rpm | 20 rpm |
| "PTO 专用参数" | ||
| "PTO 配置" | "断开" "驾驶室开关" "远程开关" "远程油门" |
"断开" |
| "PTO 发动机转速上限" | 600 到 2120 rpm | 2120 rpm |
| "PTO 发动机转速设置转速（0 = 关闭）" | 低怠速到 PTO TEL 转速 | 0 |
| "PTO 发动机设定转速" | 低怠速转速到 PTO TEL 转速 | 0 |
| "PTO 到设定转速" | "是" "否" |
"否" |
| "PTO 驾驶室控制转速限制" | "低怠速转速" "TEL rpm" "PTO TEL 转速" |
"TEL rpm" |
| "PTO 停用车速限制" | 2 到 204 km/h (1 到 127 mph) |
2 km/h (1 mph) |
| "扭矩限制" | 270 N·m（200 lb ft）到额定扭矩 | 2700 N·m (2000 lb ft) |
| "PTO 停机时间" | 3 到 1440 分钟 | 0 |
| "PTO 启动冷却风扇" | "正常" "连续" |
"正常" |
| "发动机/档位参数" | ||
| "低档位发动机转速限制" | 1100 到 2120 rpm | 2120 rpm |
| "低档位关闭速度" | 5 到 48 km/h (3 到 30 mph) |
5 km/h (3 mph) |
| "中间档位发动机转速限制" | 1100 到 2120 rpm | 2120 rpm |
| "中间档位关闭速度" | 8 到 80 km/h (5 到 50 mph) |
8 km/h (5 mph) |
| "减档保护转速限制" | 1300 到 2120 rpm | 2120 rpm |
| "减档保护打开速度" | 48 到 204 km/h (30 到 127 mph) |
204 km/h (127 mph) |
| "发动机转速上限（TEL）" | 1600 到 2120 rpm 1600 到 2150 rpm (1) |
取决于发动机额定值 |
| "带下降的发动机转速上限" | "是" "否" |
"否" |
| "低怠速发动机转速" | 600 到 750 rpm | 600 rpm |
| "变速箱类型" | "手动" "自动选项 1" "自动选项 2" "Eaton Top 2" |
"手动" |
| "带巡航开关的 Eaton Top 2 超越" | "是" "否" |
"否" |
| "最高齿轮传动比" | 0.000 到 3.750 | 0.000 |
| "最高齿轮传动比减去一个传动比" | 0.000 到 3.750 | 0.000 |
| "最高齿轮传动比减去两个传动比" | 0.000 到 3.750 | 0.000 |
| "定时器参数" | ||
| "怠速停机时间" | 3 到 1440 分钟 | 0 分钟 |
| "允许怠速停机超越" | "是" "否" "基于外界温度" "J1587 基于外界温度" |
"是" |
| "怠速停机最低外界温度" | −40° 到 49°C (−40° 到 120°F) |
49 °C (120 °F) |
| "怠速停机最高外界温度" | −40° 到 49°C (−40° 到 120°F) |
49 °C (120 °F) |
| "A/C 开关风扇接通时间" | 1 到 600 秒 | 0 秒 |
| "发动机减速器在高速模式时的风扇" | "是" "否" |
"是" |
| "发动机减速器延迟" | 0.0 到 5.0 秒 | 0.0 秒 |
| "发动机监测参数" | ||
| "Engine Monitoring Mode（发动机监测模式）" | "关闭" "警告" "减额" "停机" |
"警告" |
| "冷却液液位传感器" | "是" "否" |
"是" |
| "保养参数" | ||
| "保养指示器模式" | "断开" "手动距离" "手动小时数" "自动距离" "自动小时数" |
"断开" |
| "PM 1 周期（手动保养指示器模式）" | 8050 到 56325 km (5000 到 35000 英里) 100 到 750 小时 |
24140 km (15000 英里) 300 小时 |
| "发动机机油容量"（自动保养指示器模式） | 19 到 57 L (20 到 60 qt) |
C-10： 34 L (36 qt) C-12： 34 L (36 qt) 3406E： 38 L (40 qt) |
| "行程参数" | ||
| "燃油修正系数" | −63.5 到 63.5 | 0 |
| "仪表板显示屏访问参数" | ||
| "仪表板 - 改变燃油修正系数" | "是" "否" |
"否" |
| "仪表板 -PM1 复位" | "是" "否" |
"否" |
| "仪表板 - 车队行程复位" | "是" "否" |
"否" |
| "仪表板 - 状态选择" | "是" "否" |
"是" |
| "防盗系统控制" | "是" "否" |
"否" |
| "防盗密码" | 四位字符 | 0000 |
| "快速停机速率" | 0 到 24 km/h/s(0 到 15 mph/s） | 0 km/h/s（0 mph/s） |
| "输出选择" | ||
| "辅助输出 2" | "无" "辅助制动" "发动机运转输出" "停机输出" "换档电磁阀" |
"辅助制动" |
| "辅助输出 3" | "无" "发动机运转输出" "停机输出" "锁定电磁阀" "冷却风扇 2 号输出" |
"无" |
| "辅助输出 4" | "冷却风扇" "辅助制动" "发动机运转输出" "停机输出" |
"冷却风扇" |
| "风扇控制类型" | "无" "接通/断开" "三速风扇" |
"接通/断开" |
| "用户密码" | ||
| "客户密码（1）" | 8 位数字 可用字符取决于维修工具。 |
|
| "客户密码（2）" | ||
| "数据链路参数" | ||
| "传动系数据链路" | "断开" "J1922" "J1939" "J1922 和 J1939" |
"J1922" |
| "ECM 日期/时钟" | ||
| "月，天，年，小时，分钟，秒" | "mmm dd yyy, aa:abb:cc" | |
| "参数锁定" | ||
| 关于可锁定参数的列表，请参阅故障诊断与排除, "客户指定参数"。 | "解锁/锁定" | "锁定" |
Show/hide table
| ( 1 ) | 3406E 额定值提供此扩展范围。 |
Caterpillar Information System:
C9 Urban Transit Bus Engine 0071-11 Engine Shutdown Override Switch Occurrence
C15 and C18 Industrial Engines Front Cover - Install
C13, C15, and C18 Generator Set Engines Low Power/Poor or No Response to Throttle
C15 and C18 Industrial Engines Front Cover - Remove
C13, C15, and C18 Generator Set Engines Intermittent Engine Shutdown
C13, C15, and C18 Generator Set Engines Engine Will Not Crank
3406E, C-10 and C-12 On-highway Engines Customer Specified Parameters
3508B, 3512B, and 3516B High Displacement Generator Sets Starting with Jump Start Cables
3408E and 3412E Engines for Caterpillar Built Machines CID 0164 FMI 04 Injector Actuation Pressure voltage low
C13, C15, and C18 Generator Set Engines Engine Cranks but Will Not Start
G3408 and G3412 Engines Overhaul (Top End)
G3408 and G3412 Engines Overhaul (Major)
G3408C and G3412C Engines Engine Oil and Filter - Change
C13, C15, and C18 Generator Set Engines Event Codes
G3408C and G3412C Engines Overhaul (Major)
G3408C and G3412C Engines Overhaul (Top End)
3406E, C-10 and C-12 On-highway Engines Customer Specified Parameters Worksheet
G3408C and G3412C Engines Reference Material
3412E Petroleum Engine E040 Low Engine Oil Pressure Shutdown
3412E Petroleum Engine E053 Low Fuel Pressure Warning
3412E Petroleum Engine E100 Low Engine Oil Pressure Warning
G3500 Engines Pressure Sensor
3412E Petroleum Engine Analog Sensor Supply Circuit - Test
C15 Petroleum Engines Flywheel Housing - Remove and Install