Front Cover - Install
Show/hide table
| 所需工具 | |||
|---|---|---|---|
| 工具 | 零件号 | 零件描述 | 数量 |
| A | 155-0695 | 螺纹锁固胶 | - |
Show/hide table
| 注意 |
|---|
|
保持所有零件清洁无杂质。 杂质会造成快速磨损和缩短部件寿命。 |
- 如果螺柱 (4) 松开或者螺纹损坏，请在前壳体 (1) 中安装新的螺柱。 将工具 (A) 涂抹在螺柱的螺纹上。 将螺柱安装在前壳体 1 中。 将 O 形密封圈 (5) 安装到螺柱上。
- 将密封 (8) 安装在前盖 (2) 上。
- 将前盖 (2) 安装在螺柱 (4) 上。 安装垫圈 (6) 和螺柱 (7) 上。
- 安装半圆头螺钉 (3)。 拧紧半圆头螺钉至扭矩为
21 ± 3 N·m (15 ± 2 lb ft) 。
Show/hide table
| |
| 图 1 | g01268777 |
Caterpillar Information System:
C13, C15, and C18 Generator Set Engines Low Power/Poor or No Response to Throttle
C15 and C18 Industrial Engines Front Cover - Remove
C13, C15, and C18 Generator Set Engines Intermittent Engine Shutdown
C13, C15, and C18 Generator Set Engines Engine Will Not Crank
3406E, C-10 and C-12 On-highway Engines Customer Specified Parameters
3508B, 3512B, and 3516B High Displacement Generator Sets Starting with Jump Start Cables
3408E and 3412E Engines for Caterpillar Built Machines CID 0164 FMI 04 Injector Actuation Pressure voltage low
C13, C15, and C18 Generator Set Engines Engine Cranks but Will Not Start
G3408 and G3412 Engines Overhaul (Top End)
G3408 and G3412 Engines Overhaul (Major)
G3408 and G3412 Engines Starting with Jump Start Cables
3406E, C-10 and C-12 On-highway Engines Vehicle Wiring Harness Diagram
C9 Urban Transit Bus Engine 0071-11 Engine Shutdown Override Switch Occurrence
3406E, C-10 and C-12 On-highway Engines Customer Specified Parameters Table
G3408C and G3412C Engines Engine Oil and Filter - Change
C13, C15, and C18 Generator Set Engines Event Codes
G3408C and G3412C Engines Overhaul (Major)
G3408C and G3412C Engines Overhaul (Top End)
3406E, C-10 and C-12 On-highway Engines Customer Specified Parameters Worksheet
G3408C and G3412C Engines Reference Material
3412E Petroleum Engine E040 Low Engine Oil Pressure Shutdown
3412E Petroleum Engine E053 Low Fuel Pressure Warning
3412E Petroleum Engine E100 Low Engine Oil Pressure Warning
G3500 Engines Pressure Sensor