3408B and 3408C Industrial and Marine Engines Caterpillar


Turbocharger

Usage:

3408B 1LG


Illustration 1g01430827
Typical example

(1) Clamps

To tighten the clamps on the turbocharger, use the following procedure:

  1. Tighten the clamp.

    Tighten the clamp to the following torque. ... 14 ± 1 N·m (10 ± 1 lb ft)

  2. Gently tap the clamp with a soft faced hammer.

  3. Again tighten the clamp.

    Tighten the clamp to the following torque. ... 14 ± 1 N·m (10 ± 1 lb ft)

Caterpillar Information System:

3126B Petroleum Engine Belt - Inspect
3512B Petroleum Engine Battery or Battery Cable - Disconnect
3126B Petroleum Engine Battery Electrolyte Level - Check
C15 and C18 Engines for Caterpillar Built Machines Cylinder Head - Install
C15 and C18 Engines for Caterpillar Built Machines Cylinder Head - Remove
3126B Marine Engines Low Power/Poor or No Response to Throttle
C-15 Petroleum Engine Refill Capacities and Recommendations
C7 Marine Engine Engine Monitoring System (EMS)
G3300 Engines Refill Capacities and Recommendations
C32 Petroleum Engines Starting with Jump Start Cables - Do Not Use This Procedure in Hazardous Locations that have Explosive Atmospheres
C7 Marine Engine Flywheel
C15 and C18 Engines for Caterpillar Built Machines Pistons and Connecting Rods - Assemble
C-10 Petroleum Engine Engine Oil and Filter - Change
C7 Marine Engine Cylinder Block Cover Group
G3600 Engines Additional Messages
C11 and C13 Petroleum Engines Starting Motor - Inspect - If Equipped
2004/04/01 Engine Harness Assembly (Bypass) Flashes Messenger When Communication Through the Service Connector is Not Possible {0779, 0781}
C7 Marine Engine Electronic Unit Injector
C-15 Petroleum Engine Plate Locations and Film Locations
C7 Marine Engine Sensors and Electrical Components
C27 and C32 Engines for Caterpillar Built Machines Engine Will Not Crank
C15 and C18 Engines for Caterpillar Built Machines Fuel Priming Pump - Remove and Install
C13, C15, and C18 Generator Set Engines CID 0274 FMI 03 Atmospheric Pressure open/short to +batt
2004/02/01 Lubricate O-Ring Seals Prior to Installing the Wastegate Control Solenoid {1057, 5479}
Back to top
The names Caterpillar, John Deere, JD, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
CH-Part.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only.