CID 0274 FMI 03 Atmospheric Pressure open/short to +batt
产生此代码的情况:
电子控制模块（ECM）可检测以下状况：
- 大气压力传感器送来的信号电压高于 4.95 VDC 超过 30 秒。
- ECM 至少已通电两秒钟。
系统响应:
ECM 将记录诊断代码并触发快照。 ECM 将缺省大气压力为 100 kPa (15 psi)。
发动机功率会降额百分之十。
测试步骤 1. 进行以下的诊断步骤: 发动机压力传感器开路或短路 - 测试
结果:
- 正常 - 停止
Caterpillar Information System:
C15 and C18 Engines for Caterpillar Built Machines Fuel Priming Pump - Remove and Install
C27 and C32 Engines for Caterpillar Built Machines Engine Will Not Crank
C7 Marine Engine Sensors and Electrical Components
C-15 Petroleum Engine Plate Locations and Film Locations
C7 Marine Engine Electronic Unit Injector
2004/04/01 Engine Harness Assembly (Bypass) Flashes Messenger When Communication Through the Service Connector is Not Possible {0779, 0781}
C11 and C13 Petroleum Engines Starting Motor - Inspect - If Equipped
G3600 Engines Additional Messages
C7 Marine Engine Cylinder Block Cover Group
C-10 Petroleum Engine Engine Oil and Filter - Change
3408B and 3408C Industrial and Marine Engines Turbocharger
3126B Petroleum Engine Belt - Inspect
2004/02/01 Lubricate O-Ring Seals Prior to Installing the Wastegate Control Solenoid {1057, 5479}
C15 and C18 Engines for Caterpillar Built Machines Coolant Temperature Sensor - Remove and Install
C15 and C18 Engines for Caterpillar Built Machines Alternator - Remove and Install
UPS 250, UPS 300, UPS 500, UPS 600, UPS 750 and UPS 900 Uninterruptible Power Supply System Startup
UPS 250, UPS 300, UPS 500, UPS 600, UPS 750 and UPS 900 Uninterruptible Power Supply System Shutdown
2006/05/01 New Gaskets Are Now Available For The Oil Filter Base And The Oil Cooler. {1306, 1378}
G3304B and G3306B Engines Belts - Inspect/Adjust/Replace
C15 and C18 Engines for Caterpillar Built Machines Electronic Control Module - Remove and Install
3612 and 3616 Fast Vessel Engines Refill Capacities and Recommendations
C15 and C18 Engines for Caterpillar Built Machines Engine Oil Pressure Sensor - Remove and Install
C15 and C18 Engines for Caterpillar Built Machines Atmospheric Pressure Sensor - Remove and Install
C15 and C18 Engines for Caterpillar Built Machines Crankshaft Position Sensor - Remove and Install