Electronic Unit Injector
Show/hide table
Illustration 1 | g01049251 |
Show/hide table
Illustration 2 | g01049242 |
Detail B |
(1) Injector
(2) Backup ring
(3) Backup ring
(4) O-ring seal
(5) O-ring seal
(6) Backup ring
Show/hide table
Illustration 3 | g01049239 |
View A-A |
Note: Lubricate the bore lightly with the lubricant that is being sealed.
- Seat the injector (1) in the bore of the cylinder head.
- Tighten the shoulder bolt (7) to a torque of 6 ± 1 N·m (53 ± 9 lb in).
- Tighten the socket head bolt (8) to a torque of 12 ± 3 N·m (106 ± 27 lb in).
Caterpillar Information System:
2004/04/01 Engine Harness Assembly (Bypass) Flashes Messenger When Communication Through the Service Connector is Not Possible {0779, 0781}
C11 and C13 Petroleum Engines Starting Motor - Inspect - If Equipped
G3600 Engines Additional Messages
C7 Marine Engine Cylinder Block Cover Group
C-10 Petroleum Engine Engine Oil and Filter - Change
3408B and 3408C Industrial and Marine Engines Turbocharger
3126B Petroleum Engine Belt - Inspect
3512B Petroleum Engine Battery or Battery Cable - Disconnect
3126B Petroleum Engine Battery Electrolyte Level - Check
C15 and C18 Engines for Caterpillar Built Machines Cylinder Head - Install
C15 and C18 Engines for Caterpillar Built Machines Cylinder Head - Remove
3126B Marine Engines Low Power/Poor or No Response to Throttle
C-15 Petroleum Engine Plate Locations and Film Locations
C7 Marine Engine Sensors and Electrical Components
C27 and C32 Engines for Caterpillar Built Machines Engine Will Not Crank
C15 and C18 Engines for Caterpillar Built Machines Fuel Priming Pump - Remove and Install
C13, C15, and C18 Generator Set Engines CID 0274 FMI 03 Atmospheric Pressure open/short to +batt
2004/02/01 Lubricate O-Ring Seals Prior to Installing the Wastegate Control Solenoid {1057, 5479}
C15 and C18 Engines for Caterpillar Built Machines Coolant Temperature Sensor - Remove and Install
C15 and C18 Engines for Caterpillar Built Machines Alternator - Remove and Install
UPS 250, UPS 300, UPS 500, UPS 600, UPS 750 and UPS 900 Uninterruptible Power Supply System Startup
UPS 250, UPS 300, UPS 500, UPS 600, UPS 750 and UPS 900 Uninterruptible Power Supply System Shutdown
2006/05/01 New Gaskets Are Now Available For The Oil Filter Base And The Oil Cooler. {1306, 1378}
G3304B and G3306B Engines Belts - Inspect/Adjust/Replace