Coolant Temperature Sensor - Remove and Install
Show/hide table
| 注意 |
|---|
|
保持所有零件清洁无杂质。 杂质会造成快速磨损和缩短部件寿命。 |
Show/hide table
| 注意 |
|---|
|
在进行检验、保养、测试、调整及维修产品期间，必须小心以确保装好排放出的油液。 在打开任何舱室或解体任何储有液体的部件之前，要准备好合适的容器收集液体。 有关收集和盛接 Cat 产品上油液的适用工具和用品，请参阅专门出版物, NENG2500, "代理商维修工具目录"。 按照当地法规和要求处置所有液体。 |
注: 排出冷却液，使冷却液液位低于传感器。
Show/hide table
| |
| 图 1 | g01117079 |
(1) 冷却液温度传感器 ...
Caterpillar Information System:
2004/02/01 Lubricate O-Ring Seals Prior to Installing the Wastegate Control Solenoid {1057, 5479}
C13, C15, and C18 Generator Set Engines CID 0274 FMI 03 Atmospheric Pressure open/short to +batt
C15 and C18 Engines for Caterpillar Built Machines Fuel Priming Pump - Remove and Install
C27 and C32 Engines for Caterpillar Built Machines Engine Will Not Crank
C7 Marine Engine Sensors and Electrical Components
C-15 Petroleum Engine Plate Locations and Film Locations
C7 Marine Engine Electronic Unit Injector
2004/04/01 Engine Harness Assembly (Bypass) Flashes Messenger When Communication Through the Service Connector is Not Possible {0779, 0781}
C11 and C13 Petroleum Engines Starting Motor - Inspect - If Equipped
G3600 Engines Additional Messages
C7 Marine Engine Cylinder Block Cover Group
C-10 Petroleum Engine Engine Oil and Filter - Change
C15 and C18 Engines for Caterpillar Built Machines Alternator - Remove and Install
UPS 250, UPS 300, UPS 500, UPS 600, UPS 750 and UPS 900 Uninterruptible Power Supply System Startup
UPS 250, UPS 300, UPS 500, UPS 600, UPS 750 and UPS 900 Uninterruptible Power Supply System Shutdown
2006/05/01 New Gaskets Are Now Available For The Oil Filter Base And The Oil Cooler. {1306, 1378}
G3304B and G3306B Engines Belts - Inspect/Adjust/Replace
C15 and C18 Engines for Caterpillar Built Machines Electronic Control Module - Remove and Install
3612 and 3616 Fast Vessel Engines Refill Capacities and Recommendations
C15 and C18 Engines for Caterpillar Built Machines Engine Oil Pressure Sensor - Remove and Install
C15 and C18 Engines for Caterpillar Built Machines Atmospheric Pressure Sensor - Remove and Install
C15 and C18 Engines for Caterpillar Built Machines Crankshaft Position Sensor - Remove and Install
3126B Marine Engines Digital Sensor Supply Circuit - Test
UPS 250, UPS 300, UPS 500, UPS 600, UPS 750 and UPS 900 Uninterruptible Power Supply Load Cell - Calibrate