Flywheel
Show/hide table
 | |
| Illustration 1 | g01389276 |
Note: Refer to System Operation, Testing and Adjusting for the correct method of inspecting the flywheel.
(1) Bolt
(2) Ring gear
(3) Spring pin
(4) Shoulder
(1) Tighten the bolts that hold the flywheel to the crankshaft.
Tighten the bolts to the following torque. ... 120 ± 20 N·m (90 ± 15 lb ft)
Caterpillar Information System:
C15 and C18 Engines for Caterpillar Built Machines Pistons and Connecting Rods - Assemble
C15 and C18 Engines for Caterpillar Built Machines Pistons and Connecting Rods - Disassemble
C18 Generator set and C18 Marine Engines Pistons and Connecting Rods - Install
C15 and C18 Generator Set Engines Pistons and Connecting Rods - Remove
C7 Marine Engine Reference Material
C7 Marine Engine Engine Oil Filter Base
C-15 Petroleum Engine Engine Description
3126B Petroleum Engine Welding on Engines with Electronic Controls
C15 Petroleum Engines Engine Electronics
3126B Petroleum Engine Fire Prevention and Explosion Prevention
3126B Petroleum Engine General Hazard Information
C-15 Petroleum Engine Flywheel
C32 Petroleum Engines Starting with Jump Start Cables - Do Not Use This Procedure in Hazardous Locations that have Explosive Atmospheres
G3300 Engines Refill Capacities and Recommendations
C7 Marine Engine Engine Monitoring System (EMS)
C-15 Petroleum Engine Refill Capacities and Recommendations
3126B Marine Engines Low Power/Poor or No Response to Throttle
C15 and C18 Engines for Caterpillar Built Machines Cylinder Head - Remove
C15 and C18 Engines for Caterpillar Built Machines Cylinder Head - Install
3126B Petroleum Engine Battery Electrolyte Level - Check
3512B Petroleum Engine Battery or Battery Cable - Disconnect
3126B Petroleum Engine Belt - Inspect
3408B and 3408C Industrial and Marine Engines Turbocharger
C-10 Petroleum Engine Engine Oil and Filter - Change