Water Pump - Install
Installation Procedure
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
Show/hide table
NOTICE |
---|
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids. Refer to Special Publication, NENG2500, "Caterpillar Tools and Shop Products Guide" for tools and supplies suitable to collect and contain fluids on Caterpillar products. Dispose of all fluids according to local regulations and mandates. |
- Inspect the condition of the gasket (8). If the gasket is worn, replace the gasket.
Show/hide table
Illustration 1 | g00996176 |
- Position gasket (8) and water pump (6) on the engine.
- Install bolts (9) and nut (7) .
- Install the pulley and install bolts (5) .
Show/hide table
Illustration 2 | g01008638 |
- Install hose assembly (4) and hose assembly (2) .
- Install bolt (3). Position V-belt (1) on the pulleys.
- Fill the cooling system. Refer to Operation and Maintenance Manual, "Cooling System Coolant (ELC) - Change".
Caterpillar Information System:
G3520B Industrial Engine Throttle Actuator
C1.5 and C2.2 Marine Generator Set Engines Engine Oil Relief Valve - Remove and Install
C1.5 and C2.2 Marine Generator Set Engines Water Pump - Remove
G3304 and G3306 Engines Magneto - Disassemble
G3500 Engines Prelube Pump - Electric
C1.5 and C2.2 Marine Generator Set Engines Exhaust Manifold - Remove and Install
3500B and 3500C Marine Propulsion Engines Synchronizing Switch Not Functioning Properly
2003/05/01 New Front Crankshaft Seals and New Rear Crankshaft Seals are Now in Production {1160, 1161}
2003/05/01 New Front Crankshaft Seals and New Rear Crankshaft Seals are Now in Production {1160, 1161}
3500B and 3500C Marine Propulsion Engines Throttle Position Sensor
G3304 and G3306 Engines Magneto - Remove and Install
G3304 and G3306 Engines Accessory Drive - Assemble
C1.5 and C2.2 Generator Rotor - Remove and Install
3054C Industrial Engine Fuel Injection Pump - Remove - Bosch EVPE
3054C Industrial Engine Fuel Injection Pump - Install - Bosch EVPE
C1.5 and C2.2 Marine Generator Set Engines Water Temperature Regulator Housing - Remove and Install
3500 Engines for Caterpillar Built Generator Sets Engine Oil Filter Base
C1.5 and C2.2 Marine Generator Set Engines Expansion Tank - Remove and Install
G3520C and G3520E Generator Set Engines Cylinder Head - Disassemble
G3520C and G3520E Generator Set Engines Cylinder Head - Assemble
C1.5 and C2.2 Marine Generator Set Engines Water Temperature Regulator - Remove and Install
G3500 Engines Prelube Pump - Air
C1.5 and C2.2 Generator Exciter Field - Flash
C27 and C32 Generator Set Engines CID 0100 FMI 10 Engine Oil Pressure Sensor abnormal rate of change