Rotor - Remove and Install
Remove the Rotor
Show/hide table
Illustration 1 | g00996360 |
- Remove the generator from the engine. See Disassembly and Assembly, "Generator - Remove".
- Remove the coupling discs from the rotor shaft.
- Rest the rotor on one of the poles. Use an appropriate lifting device in order to remove the rotor from the stator. See illustration 1.
Note: If maintenance is required on the rotor, the rotor must be rebalanced before the rotor is reinstalled in the generator.
Install the Rotor
- Use an appropriate lifting device in order to install the rotor in the stator. See illustration 1.
- Install the coupling discs to the shaft of the rotor.
- Install the generator to the engine. See Disassembly and Assembly, "Generator - Install".
Caterpillar Information System:
C1.5 and C2.2 Marine Generator Set Engines Water Pump - Install
G3520B Industrial Engine Throttle Actuator
C1.5 and C2.2 Marine Generator Set Engines Engine Oil Relief Valve - Remove and Install
C1.5 and C2.2 Marine Generator Set Engines Water Pump - Remove
G3304 and G3306 Engines Magneto - Disassemble
G3500 Engines Prelube Pump - Electric
C1.5 and C2.2 Marine Generator Set Engines Exhaust Manifold - Remove and Install
3500B and 3500C Marine Propulsion Engines Synchronizing Switch Not Functioning Properly
2003/05/01 New Front Crankshaft Seals and New Rear Crankshaft Seals are Now in Production {1160, 1161}
2003/05/01 New Front Crankshaft Seals and New Rear Crankshaft Seals are Now in Production {1160, 1161}
3500B and 3500C Marine Propulsion Engines Throttle Position Sensor
G3304 and G3306 Engines Magneto - Remove and Install
3054C Industrial Engine Fuel Injection Pump - Remove - Bosch EVPE
3054C Industrial Engine Fuel Injection Pump - Install - Bosch EVPE
C1.5 and C2.2 Marine Generator Set Engines Water Temperature Regulator Housing - Remove and Install
3500 Engines for Caterpillar Built Generator Sets Engine Oil Filter Base
C1.5 and C2.2 Marine Generator Set Engines Expansion Tank - Remove and Install
G3520C and G3520E Generator Set Engines Cylinder Head - Disassemble
G3520C and G3520E Generator Set Engines Cylinder Head - Assemble
C1.5 and C2.2 Marine Generator Set Engines Water Temperature Regulator - Remove and Install
G3500 Engines Prelube Pump - Air
C1.5 and C2.2 Generator Exciter Field - Flash
C27 and C32 Generator Set Engines CID 0100 FMI 10 Engine Oil Pressure Sensor abnormal rate of change
C27 and C32 Industrial and Petroleum Engines CID 0102 FMI 10 Boost Pressure Sensor abnormal rate of change