Magneto - Remove and Install
- Place identification on each wire and on each screw on magneto (2).
- Disconnect harness assembly (1) from magneto (2).
Show/hide table
Illustration 2 g00996135 - Remove mounting bolts (3) and washers.
- Remove magneto (2) and the gasket.
Show/hide table
Illustration 1 | g00996134 |
Reference: For information about timing the magneto, refer to Testing and Adjusting, "Timing of Magneto to Engine" for the engine that is being serviced.
- Place magneto (2) and the gasket in position on the drive housing.
Show/hide table
Illustration 4 g00996145 - Install mounting bolts (3) and the washers.
Show/hide table
Illustration 5 g00996147 - Connect harness assembly (1) to magneto (2). Use the identification marks in order to connect each wire to the original terminal.
Show/hide table
Illustration 3 | g00996144 |
Caterpillar Information System:
G3304 and G3306 Engines Accessory Drive - Assemble
G3304 and G3306 Engines Accessory Drive - Disassemble
3618 Engine Turbocharger - Inspect
G3304 and G3306 Engines Service Meter - Remove and Install
3054E Industrial Engine Fuel Injection Nozzles - Install
3054E Industrial Engine Fuel Injection Nozzles - Remove
G3520B Industrial Engine Electrical Power Supply
Inspection and/or Repair Procedure to Replace Broken Crankshafts in C-15, C-16, C15, 3406C, 3406E, and 3456 Engines{1202} Inspection and/or Repair Procedure to Replace Broken Crankshafts in C-15, C-16, C15, 3406C, 3406E, and 3456 Engines{1202}
C1.5 and C2.2 Generator Generator Operation
3618 Engine Aftercooler Core - Clean/Test
3054E Industrial Engine Fuel Injection Lines - Remove and Install
G3304 and G3306 Engines Accessory Drive - Remove and Install
3500B and 3500C Marine Propulsion Engines Throttle Position Sensor
2003/05/01 New Front Crankshaft Seals and New Rear Crankshaft Seals are Now in Production {1160, 1161}
2003/05/01 New Front Crankshaft Seals and New Rear Crankshaft Seals are Now in Production {1160, 1161}
3500B and 3500C Marine Propulsion Engines Synchronizing Switch Not Functioning Properly
C1.5 and C2.2 Marine Generator Set Engines Exhaust Manifold - Remove and Install
G3500 Engines Prelube Pump - Electric
G3304 and G3306 Engines Magneto - Disassemble
C1.5 and C2.2 Marine Generator Set Engines Water Pump - Remove
C1.5 and C2.2 Marine Generator Set Engines Engine Oil Relief Valve - Remove and Install
G3520B Industrial Engine Throttle Actuator
C1.5 and C2.2 Marine Generator Set Engines Water Pump - Install
C1.5 and C2.2 Generator Rotor - Remove and Install