Accessory Drive - Assemble
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Install bearings (2) and (1) fully in the bore of housing (3).
Show/hide table
Illustration 2 g00995820 - Lower the temperature of shaft assembly (4). Install shaft assembly (4). Ensure that bearing (2) is installed fully against the shoulder on shaft assembly (4).
Show/hide table
Illustration 3 g00995821 - Place retainer plate (5) into position.
- Place the washers and the bolts that hold the retainer plate in position, but do not tighten. Push thrust plate (5) toward the groove of the shaft as far as possible. Tighten the bolts that hold thrust plate (5) in place.
Show/hide table
Illustration 4 g00995822 - Apply clean engine oil on O-ring seal (7) and install O-ring seal (7) in housing (6).
Show/hide table
Illustration 1 | g00995818 |
End By:
- Install the accessory drive. Refer to Disassembly and Assembly, "Accessory Drive - Install" for the engine that is being serviced.
Caterpillar Information System:
G3304 and G3306 Engines Accessory Drive - Disassemble
3618 Engine Turbocharger - Inspect
G3304 and G3306 Engines Service Meter - Remove and Install
3054E Industrial Engine Fuel Injection Nozzles - Install
3054E Industrial Engine Fuel Injection Nozzles - Remove
G3520B Industrial Engine Electrical Power Supply
Inspection and/or Repair Procedure to Replace Broken Crankshafts in C-15, C-16, C15, 3406C, 3406E, and 3456 Engines{1202} Inspection and/or Repair Procedure to Replace Broken Crankshafts in C-15, C-16, C15, 3406C, 3406E, and 3456 Engines{1202}
C1.5 and C2.2 Generator Generator Operation
3618 Engine Aftercooler Core - Clean/Test
3054E Industrial Engine Fuel Injection Lines - Remove and Install
G3304 and G3306 Engines Accessory Drive - Remove and Install
G3520C and G3520E Generator Set Engines Water Pump - Install
G3304 and G3306 Engines Magneto - Remove and Install
3500B and 3500C Marine Propulsion Engines Throttle Position Sensor
2003/05/01 New Front Crankshaft Seals and New Rear Crankshaft Seals are Now in Production {1160, 1161}
2003/05/01 New Front Crankshaft Seals and New Rear Crankshaft Seals are Now in Production {1160, 1161}
3500B and 3500C Marine Propulsion Engines Synchronizing Switch Not Functioning Properly
C1.5 and C2.2 Marine Generator Set Engines Exhaust Manifold - Remove and Install
G3500 Engines Prelube Pump - Electric
G3304 and G3306 Engines Magneto - Disassemble
C1.5 and C2.2 Marine Generator Set Engines Water Pump - Remove
C1.5 and C2.2 Marine Generator Set Engines Engine Oil Relief Valve - Remove and Install
G3520B Industrial Engine Throttle Actuator
C1.5 and C2.2 Marine Generator Set Engines Water Pump - Install