Water Pump - Install
安装步骤
Show/hide table
注意 |
---|
保持所有零件清洁无杂质。 杂质会造成快速磨损和缩短部件寿命。 |
- 需要用两个人将水泵 (3) 安置到发动机上。 水泵 (3) 的重量约为 34 kg (75 lb)。
Show/hide table
图 1 | g01127942 |
- 安装螺栓 (9) 以便将水泵 (3) 固定到发动机上。
- 安装螺栓 (7) ,以便将防护罩组件 (8) 固定到发动机上。
Show/hide table
图 2 | g01127935 |
- 安装螺栓 (4) ,以便将适配器 (5) 和 O 形密封圈固定到水泵 (3) 上。
- 将管组件 (6) 连接至适配器 (5) 。
- 将适配器 (2) 和密封垫连接至水泵 (3) 。
- 连接软管组件 (1) 。
- 加注冷却系统。 请参阅操作和保养手册, "冷却系统冷却液(DEAC)- 更换"。
Caterpillar Information System:
G3520C and G3520E Generator Set Engines Water Pump - Remove
3500B and 3500C Marine Propulsion Engines System Overview
C4.4 (Mech) Industrial Engine Glow Plugs - Test
2003/05/05 New QuickEvac High Speed Oil Change Arrangements Are Available {1325}
3116 and 3126 Truck Engines Rocker Shaft and Pushrod - Install
3116 and 3126 Truck Engines Rocker Shaft - Assemble
2003/05/12 New Front Crankshaft Seals and New Rear Crankshaft Seals are Now in Production {1160, 1161}
G3520B Industrial Engine PWM Sensor
3116 and 3126 Truck Engines Rocker Shaft - Disassemble
3500 Marine Engines Accumulator Pressure - Test
3500B and 3500C Marine Propulsion Engines Electronic Display Module
2003/08/01 A Pin for the Rocker Shaft Is Now Available for Parts Service {1102}
G3304 and G3306 Engines Accessory Drive - Remove and Install
3054E Industrial Engine Fuel Injection Lines - Remove and Install
3618 Engine Aftercooler Core - Clean/Test
C1.5 and C2.2 Generator Generator Operation
Inspection and/or Repair Procedure to Replace Broken Crankshafts in C-15, C-16, C15, 3406C, 3406E, and 3456 Engines{1202} Inspection and/or Repair Procedure to Replace Broken Crankshafts in C-15, C-16, C15, 3406C, 3406E, and 3456 Engines{1202}
G3520B Industrial Engine Electrical Power Supply
3054E Industrial Engine Fuel Injection Nozzles - Remove
3054E Industrial Engine Fuel Injection Nozzles - Install
G3304 and G3306 Engines Service Meter - Remove and Install
3618 Engine Turbocharger - Inspect
G3304 and G3306 Engines Accessory Drive - Disassemble
G3304 and G3306 Engines Accessory Drive - Assemble