Accessory Drive - Disassemble
Show/hide table
Required Tools | |||
Tooling | Part Number | Description | Qty |
A | 1P-0510 | Driver Gp | 1 |
8H-0663 | Bearing Puller Gp | 1 |
Start By:
- Remove the accessory drive. Refer to Disassembly and Assembly, "Accessory Drive - Remove" for the engine that is being serviced.
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Remove O-ring seal (1).
Show/hide table
Illustration 2 g00995797 - Remove bolts (2) and the washers that hold retainer plate (3) in place.
- Remove retainer plate (3).
Show/hide table
Illustration 3 g00995798 - Remove shaft assembly (4) and the bearings from housing (5).
Show/hide table
Illustration 4 g00995800 - Install Tooling (A) on shaft assembly (4).
- Use a press in order to remove bearings (6) and (7) from shaft assembly (4).
Show/hide table
Illustration 1 | g00995796 |
Caterpillar Information System:
3618 Engine Turbocharger - Inspect
G3304 and G3306 Engines Service Meter - Remove and Install
3054E Industrial Engine Fuel Injection Nozzles - Install
3054E Industrial Engine Fuel Injection Nozzles - Remove
G3520B Industrial Engine Electrical Power Supply
Inspection and/or Repair Procedure to Replace Broken Crankshafts in C-15, C-16, C15, 3406C, 3406E, and 3456 Engines{1202} Inspection and/or Repair Procedure to Replace Broken Crankshafts in C-15, C-16, C15, 3406C, 3406E, and 3456 Engines{1202}
C1.5 and C2.2 Generator Generator Operation
3618 Engine Aftercooler Core - Clean/Test
3054E Industrial Engine Fuel Injection Lines - Remove and Install
G3304 and G3306 Engines Accessory Drive - Remove and Install
G3520C and G3520E Generator Set Engines Water Pump - Install
G3520C and G3520E Generator Set Engines Water Pump - Remove
G3304 and G3306 Engines Accessory Drive - Assemble
G3304 and G3306 Engines Magneto - Remove and Install
3500B and 3500C Marine Propulsion Engines Throttle Position Sensor
2003/05/01 New Front Crankshaft Seals and New Rear Crankshaft Seals are Now in Production {1160, 1161}
2003/05/01 New Front Crankshaft Seals and New Rear Crankshaft Seals are Now in Production {1160, 1161}
3500B and 3500C Marine Propulsion Engines Synchronizing Switch Not Functioning Properly
C1.5 and C2.2 Marine Generator Set Engines Exhaust Manifold - Remove and Install
G3500 Engines Prelube Pump - Electric
G3304 and G3306 Engines Magneto - Disassemble
C1.5 and C2.2 Marine Generator Set Engines Water Pump - Remove
C1.5 and C2.2 Marine Generator Set Engines Engine Oil Relief Valve - Remove and Install
G3520B Industrial Engine Throttle Actuator