Speed/Timing Sensor - Remove and Install
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Disconnect harness assembly (3) from speed/timing sensor (2). Disconnect harness assembly (6) from speed/timing sensor (5).
- Remove bolt (1) and bracket (4).
- Remove speed/timing sensor (2) from the front housing. Remove the O-ring seal from the speed/timing sensor. Remove speed/timing sensor (5) from the front housing. Remove the O-ring seal from the speed/timing sensor.
Show/hide table
Illustration 1 | g01146856 |
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Install the O-ring seal on speed/timing sensor (2). Install the O-ring seal on speed/timing sensor (5).
- Lubricate the bores for the speed/timing sensors with clean engine oil.
- Position speed/timing sensor (2) and speed/timing sensor (5) on the front housing. Install bracket (4) and bolt (1).
- Connect harness assembly (3) to speed/timing sensor (2). Connect harness assembly (6) to speed/timing sensor (5).
- Calibrate the speed/timing sensors. Refer to Troubleshooting, "Engine Speed/Timing Sensor - Calibrate " for the calibration procedure.
Show/hide table
Illustration 2 | g01146856 |
Caterpillar Information System:
G3520C and G3520E Generator Set Engines Engine Oil and Water Pump Drive - Assemble
G3520C and G3520E Generator Set Engines Engine Oil and Water Pump Drive - Disassemble
C9 Marine Engines and C9 Marine Generator Sets Inlet Air Temperature Sensor - Remove and Install
C9 Marine Engines and C9 Marine Generator Sets Injection Actuation Pressure Sensor - Remove and Install
3516B HD Generator Set Refill Capacities
C9 Marine Engines and C9 Marine Generator Sets Fuel Temperature Sensor - Remove and Install
EMCPII+ for Gas Engines GSC CID 0168 - FMI 04
EMCPII+ for Gas Engines GSC CID 0168 - FMI 03
G3520C and G3520E Generator Set Engines Engine Oil and Water Pump Drive - Install
G3520C and G3520E Generator Set Engines Engine Oil and Water Pump Drive - Remove
C9 Marine Engines and C9 Marine Generator Sets Fuel Pressure Sensor - Remove and Install
C11, C13, and C15 On-highway Engines Diagnostic Flash Code Retrieval
EMCPII+ for Gas Engines GSC CID 0190 - FMI 02
2003/03/10 New Terminology is Now Used {7000}
EMCPII+ for Gas Engines GSC CID 0190 - FMI 03
G3520C and G3520E Generator Set Engines Exhaust Elbow - Remove and Install
EMCPII+ for Gas Engines GSC CID 0269 - FMI 03
C7 Urban Transit Bus Engines Caterpillar Driver Information Display - Messenger
3054E Industrial Engine Balancer Group - Install - If Equipped
G3500B Engines Engine Oil Lines - Turbocharger Oil Lines
G3500B Engines Exhaust Manifold
EMCPII+ for Gas Engines GSC CID 0269 - FMI 04
G3520C and G3520E Generator Set Engines Engine Oil Pump - Remove
G3520C and G3520E Generator Set Engines Engine Oil Pump - Install